检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李璿 刘鹍 刘西超 丁嘉靖 艾兵 史强 LI Xuan;LIU Kun;LIU Xichao;DING Jiajing;AI Bing;SHI Qiang(China Electric Power Research Institute,Wuhan 430074,China;State Key Laboratory of Power Grid Environmental Protection,Wuhan 430074,China;Electric Power Research Institute of State Grid Sichuan Electrical Power Company,Chengdu 610041,China)
机构地区:[1]中国电力科学研究院有限公司,湖北武汉430074 [2]电网环境保护国家重点实验室,湖北武汉430074 [3]国网四川省电力公司电力科学研究院,四川成都610041
出 处:《中国电力》2020年第2期69-75,共7页Electric Power
基 金:国家电网公司科技项目(大容量供电一体化互感器技术研究,GYW17201700096)~~
摘 要:针对供电型电压互感器供电电压随负荷而变化的实际情况,介绍了一种基于辅助互感器串联补偿技术的供电电压补偿方法。以一台额定一次电压为110/kV,额定容量为60 kV·A的单相供电型电压互感器为例,计算了其供电电压及供电容量随负荷容量及功率因数的变化率。依据变化率,设计了基于辅助互感器的供电电压自动补偿回路,可实现对供电电压±4.4 V、±8.8 V、±13.2 V、±17.6 V、±22.0 V、±26.4及±30.8 V的补偿量。分别对功率因数cosφ=1和cosφ=0.89(感性)2种情况的不同负荷容量下供电电压补偿效果进行验证,试验结果表明:增加了辅助互感器自动串联补偿回路后,供电型电压互感器的供电电压变化率由–1.80%~11.36%提高到了–3.000%~0.045%,完全满足标准对单相220 V供电电压质量的要求。采用辅助互感器的自动串联补偿技术,可以实现对供电型电压互感器供电电压的补偿,解决了由于农村负荷功率因数低,高峰负荷期供电电压偏低的问题,对提高用户电压质量提供了保障。In view of the fact that the supply voltage of power voltage transformer varies with load,this paper introduces a method of supply voltage compensation based on series compensation technology of auxiliary transformer.Taking a single-phase power supply voltage transformer with rated primary voltage of 110/3 kV and rated capacity 60 kV·A as an example,this paper calculates the variation rate of power supply voltage and capacity with load capacity and power factor.According to the rate of change,an automatic compensation circuit of power supply voltage is designed based on auxiliary transformer,which can realize the compensation of power supply voltage(+4.4 V,+8.8 V,+13.2 V,+17.6 V,+22 V,+26.4 and+30.8 V).The power factor cosφ=1 and cosφ=0.89(inductive)are used to verify the power supply voltage compensation effect under different load capacities.The experimental results show that the power supply voltage change rate of the power supply voltage transformer increases from–1.8%^+11.36%to–3%^+0.045%after adding the automatic series compensation circuit of the auxiliary transformer,and the requirements for the quality of single-phase 220 V power supply voltage can be satisfied.The automatic series compensation technology of auxiliary transformer can be used to compensate the supply voltage of power supply voltage transformer,which solves the problem of low power factor of rural load and low supply voltage in peak load period,and can provide a guarantee for improving the voltage quality of users.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.104