检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:韦秀东 卢继忠 李泽江 徐复兴[2] 傅旭东[1] WEI Xiudong;LU Jizhong;LI Zejiang;XU Fuxing;FU Xudong(School of Civil Engineering,Wuhan University,Wuhan 430072,Hubei,China;Changjiang Reconnaissan and Technology Research Institute,Ministry of Water Resources,Wuhan 430011,Hubei,China)
机构地区:[1]武汉大学土木建筑工程学院,湖北武汉430072 [2]水利部长江勘测技术研究所,湖北武汉430011
出 处:《水利水电技术》2020年第1期23-31,共9页Water Resources and Hydropower Engineering
基 金:国家自然科学基金项目(51978540,51378403)
摘 要:滑坡具有发生频率高、灾害损失严重等特点,合理计算抗滑桩滑坡推力及桩前抗力对于滑坡治理具有重要意义。滑面抗剪强度参数c、φ的设计值是根据少数钻孔取样进行试验得到或根据经验取值,不能代表滑面的平均抗剪强度,导致滑坡稳定安全系数及相应的滑坡推力曲线计算结果与实际情况存在差别。单排抗滑桩设计计算时通常不考虑桩前抗力,双排或多排抗滑桩滑坡推力的分配尚无相关规定,造成了抗滑桩滑坡推力及桩前抗力设计计算不合理。通过理论分析、数值模拟和工程应用等手段对滑坡稳定性状态及相应的滑坡推力曲线、单排抗滑桩滑坡推力与桩前抗力计算、双排抗滑桩滑坡推力分配等进行研究。研究得出:滑坡体处于极限平衡状态的判定依据为滑坡末端条块剩余滑坡推力T n=0和滑坡体天然边坡稳定系数K=1.0,两个条件需同时满足;单排抗滑桩滑坡推力及桩前抗力设计计算中,当滑坡天然稳定系数K≥1.0时,采用实际c、φ求得的设计滑坡推力与实际滑坡推力之差作为抗滑桩桩上的设计值能保证滑坡的稳定;当K<1.0时,应采用实际c、φ求得的设计滑坡推力曲线与桩前剩余抗滑力之差作为抗滑桩设计值。提出的考虑桩前土体剩余下滑力的设计计算方法能使双排抗滑桩更合理地分配滑坡推力。研究成果对抗滑桩的设计计算具有一定参考价值。The landslide is characterized by high frequency of occurrences and serious disaster losses,so it is of great significance to reasonably calculate the landslide thrust and pre-pile resistance of anti-slide pile for landslide control.The design values of the shear strength parameters c andφof slip plane are obtained from a few boring samples or the relevant experiences,and then cannot represent the mean shear strength of slip plane,thus lead to the differences between the calculation results of both the safety coefficient and the corresponding thrust curve of landslide and the actual situations.The front resistance of pile is usually not considered during the design of the single row anti-slide pile,while no any relevant specifications on the distribution of the landslide thrust are there for the dual-row or multi-row anti-slide piles,which makes the design calculations of both the landslide thrust and the front resistance of the anti-slide pile unreasonable.By means of theoretical analysis,numerical simulation and engineering application,the landslide stability status and the corresponding landslide thrust curve,the calculations of the landslide thrust and the front resistance of the single-row anti-slide pile,the landslide thrust distribution of the dual-row anti-landslide pile are studied.The study result shows that the determination criteria for the landslide body in the limit equilibrium state are the residual landslide thrust at the landslide end block of T n=0 and the the the natural slope stability coefficient of K=1.0 and both the conditions are necessary to be simutaneously satisfied.In the calculations of the landslide thrust and the front resistance of the single-row anti-slide pile,the stabilty of landslide can be guaranteed by the difference between the the designed landslide thrust obtained from the actual c andφand the actual landslide thrust.When K<1.0,the difference between the the designed landslide thrust obtained from the actual c andφand the actual landslide thrust must be taken as the des
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28