中隔墩长度对斜式轴伸泵装置出水流道水力特性的影响  

Influence of middle pier lengths on hydraulic characteristic of outlet conduit in pump system with slanted extension shaft

作　　者：徐磊[1] 夏斌 施伟 刘军 颜士开 陆林广[1] Xu Lei;Xia Bin;Shi Wei;Liu Jun;Yan Shikai;Lu Linguang(College of Hydraulic Science and Engineering,Yangzhou University,Yangzhou 225009 China;The Eastern Route of South-to-North Water Diversion Project Jiangsu Water Source Co.,Ltd.,Nanjing 210019,China)

机构地区：[1]扬州大学水利科学与工程学院,扬州225009 [2]南水北调东线江苏水源有限责任公司,南京210019

出　　处：《农业工程学报》2020年第1期74-81,共8页Transactions of the Chinese Society of Agricultural Engineering

基　　金：国家自然科学基金（51309200,51779215）;中国博士后科学基金（2013M540469）;江苏省博士后科研基金（1301021A）

摘　　要：为研究大型低扬程泵站斜式出水流道水力特性,采用数值模拟方法对某斜20°轴伸泵装置三维湍流流场进行了数值计算,发现斜式出水流道内存在严重的偏流问题,基于4种计算方案的数值模拟结果分析了偏流的成因,在研究了中隔墩长度对斜式出水流道流态和水头损失影响的基础上提出了解决偏流的措施,并得到模型试验的验证。研究结果表明:顺水流方向看,中隔墩长度为14 m时的斜式出水流道内的主流明显偏于左侧,在流道右侧下部存在较大范围的旋涡区;导叶体出口具有较大周向速度分量的水流呈螺旋状进入"S"形弯曲的斜式出水流道,两者相互作用导致斜式出水流道产生偏流;随着中隔墩长度的增加,斜式出水流道左右孔的偏流系数逐渐减小、流道水头损失呈先减小再增大趋势,当中隔墩加长至23.35m时出水流道左右两侧的出流流量达到基本相等;采用长中隔墩斜式出水流道的泵装置模型试验最优工况点效率达到80.56%,泵装置模型试验结果与数值模拟结果一致,取得了预期的纠偏效果,得到有关工程设计院的认可,并应用于工程实际。Pump system with slanted extension shaft is one of the main pump systems in large low head pump station. In order to improve the flow pattern in the slanted outlet conduit and increase hydraulic performance of pump system, the three dimension turbulent flow field was calculated for the pump system with 20° shaft extension in a large low head pump station based on the Reynolds-averaged Navier-Stokes equations and standard k-e turbulent model. By the method of numerical simulation, flow fields in outlet conduits were analyzed and compared for 4 kinds of calculation schemes which were straight outlet conduit without rotation, S-shaped curve outlet conduit without rotation, straight outlet conduit with rotation and S-shaped curve outlet conduit with rotation. Based on the analyses, the cause of serious bias flow in the slanted outlet conduit was analyzed. According to the influence of length of middle pier on the bias coefficient and hydraulic loss of the slanted outlet conduit, the method of solving the bias flow problem was put forward, and the fittest middle pier length was chosen, and the hydraulic performance of the pump system was tested. The research results showed that there was serious bias flow in slanted outlet conduit when the length of middle pier was 14 m. Looking from the direction of downstream flow, the main flow was obviously skewed to the left side of the slanted outlet conduit, while a large range of vortex area appeared in the lower right part of the outlet conduit, and the discharge of the left hole was obviously than that of the right hole. There was no bias flow in the straight and the S-shaped curved outlet conduits when the flow at the conduit inlet with no rotation.There was no bias flow in the straight outlet conduit while there was obviously bias flow in the S-shaped curved outlet conduit when the flow at the conduit inlet with rotation. Therefore, the flow with larger residual circumferential velocity component at the guide vane outlet enters into the S-shaped curved outlet conduit in a

关 键 词：泵 数值模拟 流场 斜式轴伸泵装置 出水流道 中隔墩 

分 类 号：TV131[水利工程—水力学及河流动力学]