检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李秀山 施威 阮天新 朱建华 陆松杰 张岩 LI Xiu-shan;SHI Wei;RUAN Tian-xin;ZHU Jian-hua;LU Song-jie;ZHANG Yan(School of Electronics and Information Engineering,Harbin Institute of Technology(Shenzhen),Shenzhen 518055,China;Shenzhen Zhenhua Fu Electronics Co,Ltd,Shenzhen 518109,China)
机构地区:[1]哈尔滨工业大学(深圳)电子与信息工程学院,广东深圳518055 [2]深圳振华富电子有限公司,广东深圳518109
出 处:《磁性材料及器件》2020年第1期22-25,共4页Journal of Magnetic Materials and Devices
摘 要:为了降低叠层片式电感器(MLCI)在过载电流下的开路失效几率,提高MLCI的可靠性,研究了MLCI过载电流条件下热应力对内电极开路的影响。将同等型号的MLCI样品分为三组,分别放置于-55℃、25℃、120℃三种不同温度的环境中,通过调节电流,使得内电极电阻都达到0.57Ω且能够稳定5 min,电阻与温度的关系表明内电极温度相同,环境温度不同,热应力不同。保持加载电流的大小,直到电感器发生开路。实验结果显示:低温环境中的MLCI比高温环境中开路时间短,是因为MLCI粗细不均匀的内电极在热应力的作用下,电极较细部位发生形变,致使电阻增大,焦耳热增多,温度升高,温度达到熔点后,电极开路。In order to reduce the failure rate of open circuit of multilayer chip inductor(MLCI)under overload current and improve the reliability of MLCI,we investigated the influence of thermal stress on the open circuit property of the inner electrode under the overload current condition.The MLCIs were divided into three groups,which were placed in–55℃,25℃and 120℃environment.The resistance of inner electrodes in the three groups of MLCIs reached 0.57Ωand kept for 5 minutes via adjusting the injected current.The relationship of the resistance value and the temperature indicates that the inner electrode suffered from varies thermal stress under same inner electrode temperature and different environment temperature.Keep the injection current till the inductor opens.The results show that the open time of MLCI in low environment temperature is shorter than the one in high environment temperature.The difference of open circuit time in different environment results from the thick and thin irregularity of the MLCI inner electrodes under thermal stress condition.The thinner part of the inner electrode was easier to be deformed and suffered from higher resistance value and increased joule heat.Eventually,the temperature of the inner electrode was heated up to the melting point of electrode and further caused the open circuit of MLCI.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.171