检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:王江帅 李军[1] 王烊 柳贡慧[1,3] 李汉兴 WANG Jiangshuai;LI Jun;WANG Yang;LIU Gonghui;LI Hanxing(College of Petroleum Engineering,China University of Petroleum-Beijing,Beijing 102249,China;CNOOC Energy Development Co.,Ltd.,Shanxi branch,Jinzhong 030600,China;Beijing University of Technology,Beijing 100192,China;CNOOC Research Institute Co.,Ltd.,Beijing 100028,China)
机构地区:[1]中国石油大学(北京)石油工程学院,北京102249 [2]中海油能源发展股份有限公司山西分公司,晋中030600 [3]北京工业大学,北京100192 [4]中海油研究总院有限责任公司,北京100028
出 处:《石油科学通报》2020年第1期58-66,共9页Petroleum Science Bulletin
基 金:国家自然科学基金重点项目“深水油气钻采井筒压力控制基础研究”(51734010);中国海洋石油集团有限公司创新基金项目“全井段高效复合型钻井提速工具研究与应用”联合资助。
摘 要:为实现更大的钻进深度,本文建立了井口回压实时调节优化模型,模型通过优化实时钻进过程中的井口回压,达到实时优化井筒压力剖面的效果,从而实现更大的钻进深度。通过实例对比了回压恒定和回压实时调节两种条件下的优化结果,并分析了不同钻井参数对回压优化结果和最大钻进深度的影响,研究结果表明:与回压恒定条件下的最优化结果相比,井口回压实时调节优化模型优化了钻进过程中的井口回压,使井筒压力剖面可以更好地适应地层窄安全压力窗口,实现了更大的钻进深度;利用井口回压实时调节优化模型后,可进一步减小随钻井底压差,从而有利于储层保护和钻井提速;相比于空心球注入体积分数和排量,最大钻进深度受分离器与钻头间距和纯钻井液密度的影响更为明显。In order to achieve greater drilling depth,a real-time adjustment optimization model of wellhead backpressure was established.The model achieves a real-time and optimal wellbore pressure profile by optimizing wellbore back pressure during the real-time drilling process.Then a greater drilling depth can be achieved.The optimization results under two conditions;constant backpressure and real-time adjustment of backpressure,were compared by examples,and the influence of different drilling parameters on the optimization results of backpressure and maximum drilling depth under real-time adjustment of backpressure was analyzed.Research results show that compared with the optimization results under the condition of constant backpressure,the real-time adjustment model of wellhead backpressure can optimize the wellhead backpressure in the drilling process so that the wellbore pressure profile can better adapt to narrow safe pressure margins,which can achieve greater drilling depth.Moreover,the real-time adjustment optimization model of wellhead backpressure can further reduce the bottom-hole pressure difference,which is conducive to reservoir protection and increase of ROP.Compared with the volume fraction of hollow spheres and displacement,the maximum drilling depth is more affected by the distance between the separator and bit and the density of pure drilling fluid.
关 键 词:深水双梯度钻井 实时钻进 井口回压 优化模型 最大钻进深度
分 类 号:TE24[石油与天然气工程—油气井工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.222.182.107