检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李莹[1,2] 吕俊利[1,2] 蔡永远[1] 吕京京 仲崇强 Li Ying;LüJunli;Cai Yongyuan;LüJingjing;Zhong Chongqiang(Engineering Research Institute of Appraisal and Strengthening,Shandong Jianzhu University,Jinan 250013,China;Key Lab of Building Structural Retrofitting and Underground Space Engineering(Shandong Jianzhu University),Ministry of Education,Jinan 250101,China)
机构地区:[1]山东建筑大学工程鉴定加固研究院,济南250013 [2]建筑结构加固改造与地下空间工程教育部重点实验室,济南250101
出 处:《建筑结构》2020年第6期15-20,共6页Building Structure
基 金:国家自然科学基金项目(51878398)。
摘 要:为了对刚接约束下现浇组合梁的抗火性能进行研究,现对刚接约束下的现浇组合梁进行了恒载升温试验研究和数值模拟。在试验过程中,对试验现象进行了详细的观察记录,对现浇组合梁的温度分布和位移变化进行了测量。通过分析试验数据发现,现浇板的温度分布沿板厚方向逐渐降低,板底温度最高,40mm以下区域受火影响最为明显。现浇板会延缓钢梁上翼缘温度的升高,由于温度梯度的影响,现浇板会约束钢梁的变形;现浇板由于温度应力和荷载弯矩的影响,在板顶沿中轴线方向出现贯穿板面的裂缝,冷却后现浇组合梁有较强的变形恢复能力。刚接约束下现浇组合梁的模拟结果与试验结果符合较好,验证了数值模拟的正确性与可行性。In order to study the fire-resistance performance of cast-in-place composite beams with rigid joint constraints, the temperature rise experiment and numerical simulation of the cast-in-place composite beams with rigid joint constraints were carried out. In the process of the experiment, the experiment phenomenon was observed and recorded in detail, and the temperature distribution and displacement change of the cast-in-place composite beam were measured. Through the analysis of the experimental data, it is found that the temperature distribution of the cast-in-place slab decreases gradually along the direction of the slab thickness, the temperature at the slab bottom is the highest, and the area below 40 mm is most affected by the fire. The cast-in-place slab will delay the temperature rise of the upper flange of the steel beam. Due to the influence of the temperature gradient, the cast-in-place slab will restrain the deformation of the steel beam. Due to the influence of the temperature stress and the load bending moment, the cracks across the slab surface appear at the top along the central axis direction, and the cast-in-place composite beam has strong deformation recovery ability after cooling. The simulation results of cast-in-place composite beams with rigid joint constraints are in good agreement with the experiment results, which verifies the correctness and feasibility of the numerical simulation.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.17.157.68