颗粒度对消失模铸造TiCp/Fe复合材料组织的影响  

Effect of Particle Size on Microstructure Uniformity of Lost Foam Casting TiCp/Fe Composites

作　　者：王振兴 谭建波[1,2,3] 于延龙 李春海 Wang Zhenxing;Tan Jianbo;Yu Yanlong;Li Chunhai(Materials Science and Engineering,Hebei University of Science and Technology;Key Laboratory of Near-net Forming Technology of Hebei Province;Hebei Engineering Laboratory of Aviation Lightweight Composite Materials and Processing Technology;Shijiazhuang Industrial Pump Factory Co.,Ltd.)

机构地区：[1]河北科技大学材料科学与工程学院,石家庄050018 [2]河北省材料近净成形技术重点实验室 [3]航空轻质复合材料与加工技术河北省工程实验室 [4]石家庄工业泵厂有限公司

出　　处：《特种铸造及有色合金》2020年第5期544-549,共6页Special Casting & Nonferrous Alloys

基　　金：河北省新兴产业前沿技术开发专项资助项目(18211021D)。

摘　　要：利用消失模铸造工艺制备了TiCp增强高铬铸铁复合材料,用SEM、EDS检测及能谱分析等手段进行检测,以某渣浆泵后护板为对象,研究了TiCp粒度对TiCp/Fe复合材料组织均匀性的影响。结果表明,随着颗粒度减小,颗粒经过气隙获得的运动速度越大,分布越均匀。相同粒度的复合材料后护板中部两侧标准偏差最小,均匀性最好。随着颗粒度的减小,标准偏差依次减小,最小为1.05。TiCp粒度为2 000目时,后护板组织均匀性最好,此时颗粒会发生分解。The TiC particle reinforced high chromium cast iron matrix composites were prepared by the lost foam casting process.Effects of the particle size on TiCp/Fe composite uniformity in a slurry pump back guard were investigated by SEM,EDS and energy spectrum analysis.The results show that with the particle size decreases,thmovement speed of the particles obtained through the air gap is increased and the distribution is more uniformThe uniformity is desirable of the composite castings of minimum standard deviation of the two sides at the samparticle size.The standard deviation of the composites is decreased with the particle size decreased to a minimum of 1.05.When the TiC particle size is 2 000 mesh,the rear panel has the satisfied uniformity,and the particles ardecomposed.

关 键 词：消失模铸造工艺 高铬铸铁 复合材料 颗粒粒度 组织均匀性 

分 类 号：TB333[一般工业技术—材料科学与工程] TG249.6[金属学及工艺—铸造]