检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:赵伟文 谢志军[1] 王陈璐 方子睿 俞建成[1] ZHAO Wei-wen;XIE Zhi-jun;WANG Chen-lu;FANG Zi-rui;YU Jian-cheng(Faculty of Electrical Engineering and Computer Science,Ningbo University,Ningbo 315211,China;School of Material Science and Chemical Engineering,Ningbo University,Ningbo 315211,China;Institute of Mass Spectrometry,Ningbo University,Ningbo 315211,China)
机构地区:[1]宁波大学信息科学与工程学院,浙江宁波315211 [2]宁波大学材料科学与化学工程学院,浙江宁波315211 [3]宁波大学质谱技术与应用研究院,浙江宁波315211
出 处:《质谱学报》2020年第4期386-392,共7页Journal of Chinese Mass Spectrometry Society
基 金:国家自然科学基金(60902097,61971248);浙江省重点科技项目(2020C03064);宁波市国际合作项目(2016D10008);海洋电子信息产业智慧资源配置与分享平台研究与开发项目(2017GY116);宁波市2025重点研发项目(2019B10125,2019B10028,2018B10075);宁波大学“海洋生物技术与海洋工程”学科群专项项目(422004582)资助。
摘 要:在质谱数据分析中,重叠峰分峰是一个重要的预处理步骤。本文建立了一种基于分辨率增强算法的质谱重叠峰分峰方法。首先,采用对信号及其负二阶微分进行加权的峰锐化算法来提高峰分辨率,解决拖尾峰和前延峰的问题。然后,对锐化后的信号进行连续小波变换,实现信号去噪并得到谱峰的粗略参数。最后,将这些粗略参数作为曲线拟合的输入,通过非线性拟合得到最终精确的拟合参数,解决了大量峰重叠情况下的重叠峰分峰问题。理论分析和实验结果表明,解析后的分离度在仿真原始分离度上均有一定提升。与小波变换法、交点垂线法和比例分配法相比,该方法可以更加准确地实现重叠峰分峰。Overlapping peak separation is an important pretreatment step in mass spectrometry data analysis.Because the resolution of the instrument is not high,overlapping peaks appears in the mass spectrum.The position of the characteristic peak can not be accurately determined and have influence on the identification of compounds.The intersection vertical method and the proportional distribution method use geometric method to resolve overlapping peaks which can not solve the problem of trailing peak and leading peak.Wavelet is mainly used to denoise and determine the number of peaks and the position of overlapping peaks.Under the condition of a large number of peaks overlapping,the overlapping peaks can not be accurately separated.In this paper,a new method based on resolution enhancement algorithm was proposed.Firstly,the peak resolution was improved by using a peak sharpening algorithm which weight the signal and its negative second order differential,solving the problem of tailing peak and leading peak.Then,the sharpened signal was transformed by continuous wavelet transform,the signal was denoised and the rough parameters of the spectral peak were estimated.Finally,taking these rough parameters as the input of curve fitting,the accurate fitting parameters could be obtained by nonlinear fitting.Under the condition of a large number of peaks overlapping,the overlapping peaks could be accurately separated.The results showed that the resolution was improved in the simulation of the original resolution after resolution.Compared with the wavelet transform method,the intersection vertical method and the proportional distribution method,the proposed method could realize the overlapping peak separation more accurately.The white Gaussian noise with different signal-to-noise ratio(SNR)was added to the data by using the“AWGN”function in MATLAB.The overlapping peaks with different signal-to-noise ratios were simulated.The results showed that the relative error of this proposed method was obviously smaller than that of the wav
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.3