水蒸气润滑干气密封启动过程研究  

Study on startup operation of dry gas seal with steam lubrication

作　　者：范瑜 宋鹏云[1] 许恒杰[1] FAN Yu;SONG Pengyun;XU Hengjie(Faculty of Chemical Engineering,Kunming University of Science and Technology,Kunming 650500,Yunnan,China)

机构地区：[1]昆明理工大学化学工程学院,云南昆明650500

出　　处：《化工学报》2020年第8期3671-3680,共10页CIESC Journal

基　　金：国家自然科学基金项目(51465026)。

摘　　要：水蒸气为实际气体,研究水蒸气润滑干气密封的启动过程,对汽轮机密封的启动、运行有重要意义。选用GW模型,由实验确定接触模型参数。经实验确定的接触模型参数为:微凸体曲率半径R=3.7310μm,微凸体面积密度η=0.1458μm^-2。在开启过程中,随着转速增加,气膜承载力持续增加,闭合力保持不变,接触力迅速减小至零。当转速达到一定值时,气膜承载力与闭合力相等,此时,密封端面完全脱开。以微凸体曲率半径R为变量时,R增大,接触力增加、气膜承载力减小;以微凸体面积密度η为变量时,η增加,接触力增加、气膜承载力减小。将本文接触模型数据和Etsion等的模型数据对比,分析接触模型参数对开启性能的影响。发现依据本文接触模型数据计算的接触力稍小、开启力稍大、槽根压力稍大,在低转速时,泄漏率稍小、开漏比稍大。Steam is an actual gas,so it is of great significance to study the starting process of steam-lubricated dry gas seals for the start-up and operation of steam turbine seals.The GW contact model is used whose contact model parameters are determined by experiments.The results show that the contact model parameters determined by way of experiment:asperity curvature radius R=3.7310μm,asperity area densityη=0.1458μm^-2.During the opening process,as the rotating speed increases,the gas film bearing capacity continues to increase,and the closing force remains unchanged,but the contact force rapidly decreases to zero.When the rotating speed reaches certain value,the bearing capacity of the gas film is equal to the closing force,and the sealing end face is completely separated from each other.When the curvature radius R of the micro-convex body is used as a variable,the gas film bearing capacity increases,and the contact force decreases with R decreasing.With micro-convex body area densityηbeing a variable,the contact force increases,the gas film bearing capacity reduces.By comparing the contact model data of this paper with the model data of Etsion et al.,the influence of contact model parameters on the opening performance is analyzed.It is found that based on the contact model data obtained in this paper,the contact force is slightly smaller,and both the opening force and the pressure at the groove root are mildly larger.The leakage rate is slightly smaller,and the ratio of the opening force to the leakage is lightly larger at low speed.

关 键 词：干气密封 接触力 轮廓仪 均方根 均方根斜率 

分 类 号：S277.9[农业科学—农业水土工程] TH136[农业科学—农业工程]