检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:杜文博 黄斌[2] 汪明元 卢继忠 郑熠迪 DU Wenbo;HUANG Bin;WANG Mingyuan;LU Jizhong;ZHENG Yidi(PowerChina Huadong Engineering Corporation Limited,Hangzhou 311122,China;School of Civil Engineering,Wuhan University,Wuhan 430072,China)
机构地区:[1]中国电建集团华东勘测设计研究院有限公司,浙江杭州311122 [2]武汉大学土木建筑工程学院,湖北武汉430072
出 处:《人民长江》2020年第9期189-193,共5页Yangtze River
基 金:湖北省自然科学基金项目(2019CFB488);中电建集团科技项目(DJ-ZDXM-2014-17)。
摘 要:海洋黏土与陆域一般黏土相比,其孔隙水具有一定的含盐量,孔隙水含盐量会影响其力学特性,因此试验中在制样饱和时不宜改变其孔隙水的含盐量。对饱和度较低的海洋黏土,需制备与海洋土中孔隙水含盐量一致的水样,然后再进行真空法饱和;对饱和度大于92%的海洋黏土样,建议采用反压力法饱和。由于海洋黏土在取样、运样和样品存贮过程中受扰动影响,试验时不排水强度降低50%甚至更多。基于扰动样不排水强度的SHANSEP法开展室内扰动模拟的试验研究,对通过预固结法减少扰动导致的试验偏差作进一步的探讨。试验结果表明:预固结应力的选取与土样的扰动方式和扰动程度相关,针对我国现有的岩土勘察技术,预固结应力选取较国外标准的折减系数(75%~80%)要低得多。因此如何合理地选取预固结应力,需要不断地积累工程经验,并经工程检验后进一步推广应用。Compared with the general clay in continent,marine clay has certain amount of salt in pore water.The salt content of pore water in marine clay can affect its mechanical properties,so it is not appropriate to change the salt content of pore water when preparing a saturated sample.For marine clay with low saturation,salt water containing the same salt content as the pore water in the marine soil must be prepared and then clay samples could be saturated by vacuum method.For marine clay samples with saturation greater than 92%,it is best to use a back-pressure method to saturate the sample.In the process of sampling,sample is susceptible to disturbance during transportation,sampling and storage,so its undrained strength decreases by 50%or more.Based on the SHANSEP method of undrained strength of the disturbance sample,the experimental study on reducing clay disturbance induced test error by the pre-consolidation method was discussed.The results show that the determination of pre-consolidation stress is related to the disturbance mode and degree of soil samples.For existing geotechnical investigation technology in China,the selection of pre-consolidation stress is often much lower than the reduction coefficient(75%~80%)of foreign standards.How to reasonably select the pre-consolidation stress needs to accumulate engineering experience continuously and engineering inspection.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.191.178.45