检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:杨俊英[1] 高飞[1] 陈龙 YANG Junying;GAO Fei;CHEN Long(Engineering Research Center of Continuous Extrusion,Ministry of Education,Dalian Jiaotong University,Dalian Liaoning 116028)
机构地区:[1]大连交通大学连续挤压教育部工程研究中心,辽宁大连116028
出 处:《中国铁道科学》2020年第5期108-114,共7页China Railway Science
基 金:国家重点研发计划项目(2016YFB0301403);辽宁省教育厅科学研究项目(JDL2020025);大连市青年科技之星项目(2017RQ135)。
摘 要:将摩擦块设计为2侧接触和中间接触2种接触形式,利用轨道列车缩比惯性制动试验台,分别在制动压力为0.50,0.75和1.00 MPa,制动速度为50,80,120,160和200 km·h-1条件下,研究局部接触形式对制动盘表面温度和摩擦性能的影响,并与全接触形式对比。结果表明:局部接触的位置对盘面温度和摩擦系数的影响明显;在制动速度为200 km·h-1、制动压力为1.00 MPa工况下,局部接触导致摩擦系数降低约10%左右;相对于全接触,中间接触时盘面峰值温度升高约31%、最大温差增大约37%,2侧接触时盘面峰值温度下降约11%、最大温差减小约68%。其原因在于中间接触时接触区域与盘面高能量区重合,起到了加剧温度集中程度的作用,而2侧接触时接触区域偏离高能量区,有助于改善盘面温度的均匀性。The bilateral contact and middle contact patterns were designed for the friction blocks. The effects of local contact patterns on the surface temperature of the brake disc and friction performance were studied on the reduced-scale inertia braking test bench of track and train under the braking pressures of 0. 50, 0. 75 and 1. 00 MPa at the braking speeds of 50, 80, 120, 160 and 200 km·h-1 respectively, and were compared with those of full contact pattern. Results show that the position of local contact has an obvious effect on the surface temperature of the disc and friction coefficient. At the speed of 200 km·h-1 and the braking pressure of 1. 00 MPa, the friction coefficient is reduced by about 10% due to local contact. Compared with the full contact, the peak temperature of disc surface rises by 31%, and the maximum temperature difference is increased by 37%for the case of middle contact, while the peak temperature decreases by 11% and the maximum temperature difference decreases by 68% under bilateral contact. The reason is that the contact area coincides with the high energy area of the disc surface during the middle contact, which intensifies the temperature concentration degree, while the contact area deviates from the high energy area during the bilateral contact, which helps to improve the temperature uniformity of disc surface.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.119.131.131