CATS5-16变速器的同步器设计  

Synchronizer Design of CATS5-16 Transmission

作　　者：高敏[1] 欧淑红 Gao Min;Ou Shuhong(Mechanical Engineering College,Northeast Electric Power Engineering,Jilin Jilin 132012;Design Department of China Huanqiu University Corporation,Jilin Jilin 132108)

机构地区：[1]东北电力大学机械工程学院,吉林吉林132012 [2]中国寰球工程公司设计部,吉林吉林132031

出　　处：《东北电力大学学报》2020年第5期40-44,共5页Journal of Northeast Electric Power University

摘　　要：文中以CATS5-16变速器各前进档所采用的锁环式同步器的工作原理为基础,通过对其工作过程的分析,对摩擦锥面的摩擦力矩的计算、同步器锥环锁止角的选定以及在合理的换档力范围内的同步时间的计算以及其他性能参数的选定等设计内容和注意事项进行了详细阐述.This article is based on the working principle of the lock ring Synchronizer used in each forward gear of the CATS5-16 transmission.Through the analysis of its working process,the calculation of the friction torque of the friction cone and the lock of the synchronizer cone are analyzed.The selection of the lock-up angle,the calculation of the synchronization time within a reasonable shift force range,and the size selection of various parameters that affect the performance of the synchronizer are described in detail.

关 键 词：摩擦 锁止角 同步器 

分 类 号：U463.2[机械工程—车辆工程]