检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:舒建国 程昌勇 SHU Jianguo;CHENG Changyong(Pearl River Water Resources Commission of the Ministry of Water Resources Technical Consulting Center,Guangzhou 510611,China)
机构地区:[1]水利部珠江水利委员会技术咨询中心,广东广州510611
出 处:《广东水利水电》2021年第1期7-12,共6页Guangdong Water Resources and Hydropower
摘 要:利用ABAQUS有限元分析软件,建立考虑基岩岩体软弱夹层结构面力学特性的二维重力坝深层抗滑稳定弹塑性计算模型。采用超载法进行水工混凝土重力坝深层抗滑稳定分析,通过观察塑性区是否贯通、计算收敛的情况得出各自的深层抗滑稳定安全系数,与用规范规定的刚体极限平衡法得到的计算结果进行对比。结果表明:①随着实践经验的不断积累,基本形成初步共识:以刚体极限平衡法计算的安全系数为安全度的主要判据,同时将有限元计算的坝体、地基的应力、位移值、超载系数K p等作为辅助判据,综合衡量坝的稳定安全度;②通过有限元计算,坝趾处的塑性区扩展方向及第三主应力扩展方向一般是倾向下游的,可作为刚体极限平衡法中第二滑裂面的倾向;③现行规范规定的刚体极限平衡法计算在实际应用时存在较大的局限性,通过分析可知,针对复杂坝基情况,可采用有限元计算方法来研究其抗滑稳定性。In this paper,the ABAQUS finite elements analysis software was used to establish the deep layer anti-sliding stability elastic-plastic calculation model for gravity dams considering the mechanical properties of the surface of the bedrock soft interlayer structure.In this paper,the sliding stability of hydraulic concrete gravity dam was analyzed by means of overload method,and the safety factors of sliding stability of hydraulic concrete gravity dam were obtained by observing whether the plastic zone was closed and calculated,and then the safety factors were compared with those obtained by rigid body limit equilibrium method.The results showed that:①With the accumulation of practical experience,a preliminary consensus is basically formed:the safety coefficient calculated by the rigid body limit equilibrium method is the main criterion of safety degree,and the stress,displacement value and overload coefficient K p calculated by the finite element method are taken as auxiliary criteria to comprehensively measure the stability and safety degree of the dam.②The limit equilibrium method of rigid body stipulated in the current code has great limitation in practical application.According to the analysis in this paper,the anti-sliding stability of complex DAMS can be studied by using the finite element method.
分 类 号:TV642.3[水利工程—水利水电工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222