检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:黄宣 孙俊威 戴维葆 陈国庆 HUANG Xuan;SUN Jun-wei;DAI Wei-bao;CHEN Guo-qing(China Energy Investment Co.Ld.,Beijing,China,10000;Guodian Nanjing Electrice Power Test&Research Co.Lid.,Nanjing.China,210031)
机构地区:[1]国家能源投资集团有限责任公司,北京100000 [2]国电南京电力试验研究有限公司,江苏南京210031
出 处:《热能动力工程》2021年第1期74-79,共6页Journal of Engineering for Thermal Energy and Power
基 金:中国国电集团科技项目(D2017Y008)。
摘 要:为解决超超临界二次再热锅炉再热汽温偏低的问题,以1 000 MW超超临界二次再热锅炉为研究对象,提出采取增设壁式再热器的方法提高再热汽温,计算了壁式再热器面积对主再热蒸汽温度的影响。计算结果表明:增设壁式再热器可提高再热汽温,当一、二次再热器各增加350 m^(2)受热面时,可使一、二次再热汽温满足设计要求,但也会导致主蒸汽严重欠温,无过热减温水时主蒸汽温度也低于设计值;采用增加壁式再热器同时提高煤水比,可使主再热蒸汽温度满足要求。In order to solve the problem of the low reheat steam temperature of the ultra-supercritical secondary reheat boiler,with the 1 000 MW ultra-supercritical secondary reheat boiler as the research object,the method of adding a wall reheater is proposed to increase the reheat steam temperature.The effect of the wall reheater area on the main reheated steam temperature is calculated.The calculation results indicate that adding a wall reheater can increase the reheat steam temperature.When the 350 m^(2) wall reheater heating surface is added to the primary reheater and the secondary reheater respectively,the primary reheat temperature and secondary reheat steam temperature can meet both design requirements.But it also causes the main steam to be under-heated,and the main steam temperature is lower than the design value when there is no superheated desuperheating water.By means of increasing the wall reheater and increasing the coal-water ratio,the main reheat steam temperature can meet the requirement.
关 键 词:超超临界 主汽温 二次再热 再热汽温 壁式再热器 煤水比
分 类 号:TM621.2[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.171