基于ProCAST的座圈熔模铸造工艺数值模拟及优化  

Numerical Simulation and Optimization of Seat Ring Investment Casting Process Based on ProCAST

作　　者：王晋忠 杨国超 杨小建[2] 李丰[2] 张怀章[2] 王剑[2] 张亚娟[2] WANG Jinzhong;YANG Guochao;YANG Xiaojian;LI Feng;ZHANG Huaizhang;WANG Jian;ZHANG Yajuan(Chinese Naval Equipment Department,Xi'an 710077,China;CSIC No.12 Research Institute,Xingping 713102,China)

机构地区：[1]海军装备部,陕西西安710077 [2]中国船舶重工集团公司第十二研究所,陕西兴平713102

出　　处：《热加工工艺》2021年第3期64-66,70,共4页Hot Working Technology

摘　　要：对座圈熔模精密铸造工艺进行了设计,采用ProCAST模拟软件计算铸件充型、凝固过程,并分析缺陷形成原因。在此基础上优化铸造工艺参数并再次进行数值模拟,得出合理的铸造工艺。经过生产验证,对采用优化后的工艺生产的铸件进行X射线探伤,没有发现缩松、缩孔等缺陷,铸件合格。The investment casting process of a seat ring was designed. The ProCAST simulation software was used to calculate the filling and solidification process of the casting, and the reasons for the formation of defects were analyzed. On this basis, the casting process parameters were optimized and numerical simulation was again performed. A reasonable casting process was obtained. After production verification, X-ray flaw detection was performed on the castings produced by the optimized process. No defects such as shrinkage cavity and shrinkage porosity are found, and the castings are qualified.

关 键 词：座圈铸件 数值模拟 熔模铸造 

分 类 号：TG255[金属学及工艺—铸造]