石墨烯-铝合金复合材料放电等离子烧结法制备及其性能研究  

Preparation and Properties of Graphene-Aluminum Alloy Composite by Spark Plasma Sintering

作　　者：荣彦[1] 张亚锋 张兰[1] 夏慧敏[1] RONG Yan;ZHANG Yafeng;ZHANG Lan;XIA Huimin(Department of Mechanics and Safety Engineering,Zhengzhou University,Zhengzhou 450000,China)

机构地区：[1]郑州大学力学与安全工程学院,河南郑州450000

出　　处：《热加工工艺》2021年第4期84-87,共4页Hot Working Technology

基　　金：河南省基础与前沿技术研究项目(152300410188)。

摘　　要：采用SPS放电等离子烧结法制备石墨烯-铝合金复合材料,研究石墨烯含量分别为0、0.1wt%、0.2wt%、0.3wt%、0.5wt%、1wt%、2wt%、3wt%和5wt%时,复合材料的显微硬度、摩擦系数和磨损率。结果表明,SPS放电等离子烧结法制备的复合材料组织较为致密,石墨烯分散均匀。随着石墨烯质量分数的增加,复合材料的硬度先增大后减小,当石墨烯的含量为0.3wt%时,复合材料的硬度达到最大值,为144.9 HV。随着石墨烯含量的增加,复合材料的摩擦系数和磨损量先减小后增大,当石墨烯的含量为0.3wt%时,复合材料的摩擦系数和磨损量达到最小值,分别为0.31和0.0037 mm3。Graphene-Al alloy composites were prepared by SPS discharge plasma sintering.The microhardness,friction coefficient and wear rate of graphene aluminum alloy composite were studied when the content of graphene were 0,0.1 wt%,0.2 wt%,0.3 wt%,0.5 wt%,1 wt%,2 wt%,3 wt%and 5 wt%,respectively.The results show that the microstructure of the composites prepared by SPS is compact and the graphene is well dispersed.With the increase of the content of graphene,the hardness of the composite increases first and then decreases.When the content of graphene is 0.3 wt%,the hardness of the composite reaches the maximum value,which is 144.9 HV.With the increase of the content of graphene,the friction coefficient and wear amount of the composite decrease first and then increase.When the content of graphene is 0.3 wt%,the friction coefficient and wear amount of the composite reach the minimum value of 0.31 and 0.0037 mm3,respectively.

关 键 词：放电等离子烧结 石墨烯-铝合金复合材料 硬度 摩擦系数 磨损量 

分 类 号：TB333.12[一般工业技术—材料科学与工程] TG174.442.1[金属学及工艺—金属表面处理]