基于双旋杯工艺的水性3C1B复合涂层的研发  

Development of Water-Based 3C1B Multilayer System by Dual-Coat-Bell Spray Process

作　　者：周乃羽 刘宏宇 吴井龙 史美慧 关帅 韩悦 Zhou Naiyu;Liu Hongyu;Wu Jinglong;Shi Meihui;Guan Shuai;Han Yue(Shenyang Research Institute of Chemical Industry Co.,Ltd.,Shenyang 110021,China)

机构地区：[1]沈阳化工研究院有限公司,沈阳110021

出　　处：《涂料工业》2021年第4期1-6,共6页Paint & Coatings Industry

摘　　要：在3C1B(三涂一烘)的工艺下,通过树脂、助溶剂、颜料的合理搭配制备了一款水性双组分中涂和一款水性双组分底色漆,中涂采用旋杯喷涂,底色漆采用两遍旋杯的喷涂方式,该配套组合能够满足产品对于多种性能的要求。同时探究了在上述工艺条件下,漆膜厚度变化以及漆雾对漆膜外观的影响,结合抗紫外穿透测试,找出了施工的最佳膜厚。结果表明:随着中涂和底色漆膜厚的增加,DOI下降,LW和SW上升,且漆雾的存在会导致外观质量下降;中涂推荐施工膜厚为12~15μm,色漆总施工膜厚为11~16μm。A two-component water-based intercoat and basecoat were prepared for the process of 3C1B(three coating and one baking)by optimized formulation,in terms of resins,co-solvents and pigments.The intercoat was applied by rotating bell spray,and the basecoat was applied by rotating bell spray with dual coats.The multilayer system could meet the requirements of the product for a variety of properties.Meanwhile,the influences of the overspray and change of the film thickness under this process on the appearance were investigated.Combined with the UV test,the optimal applied film thickness was determined.The results showed that with the increase of film thickness,DOI decreased,LW and SW increased.,and the overspray would lead to the deterioration of film appearance.The applied intercoat film thickness was(12~15)μm,and basecoat film thickness was(11~16)μm.

关 键 词：水性 3C1B 旋杯 底色漆 中涂 外观 

分 类 号：TQ639[化学工程—精细化工]