检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李科[1] 文键[1] 王斯民[2] LI Ke;WEN Jian;WANG Simin(School of Energy and Power Engineering,Xi’an Jiaotong University,Xi’an 710049,Shaanxi,China;School of Chemical Engineering and Technology,Xi’an Jiaotong University,Xi’an 710049,Shaanxi,China)
机构地区:[1]西安交通大学能源与动力工程学院,陕西西安710049 [2]西安交通大学化学工程与技术学院,陕西西安710049
出 处:《化工学报》2021年第4期1956-1964,共9页CIESC Journal
基 金:国家自然科学基金项目(51676146)。
摘 要:基于MATLAB编程,采用分布参数法构建了逆流板翅式换热器的二维计算模型,并与Claude循环氦液化器中多股流板翅式换热器的实验结果进行比较,数值结果和实验结果的吻合程度很好。研究了轴向导热对板翅式换热器换热能力的影响,发现考虑轴向导热的有效度相较于不考虑轴向导热降低了21.8%,且由于轴向导热将隔板冷端和热端的绝热边界条件施加的影响向换热器计算域内部传递,引发了换热器入口区域流体温度的畸变。而在隔板的冷端和热端分别采取定壁温或定热流的边界条件时,流体入口区域温度畸变几乎消失。在考虑轴向导热时,与隔板两端绝热边界条件相比,定壁温边界条件有效度增加35.8%(εc)和31.7%(εh),定热流边界条件有效度增加22.8%(ε)。Based on MATLAB program and by implementing the distributed parameter method,the 2-D model of reverse-flow plate fin heat exchanger(PFHE)was constructed.The numerical results were compared with the experimental results in a multi-stream PFHE used in liquefier in Claude cycle,and the numerical results were in good agreement with the experimental results.The effect of the axial conduction on heat transfer performance of PFHE was investigated,and it was observed that the effectiveness of PFHE considering axial conduction decreased by 21.8%,compared with that without considering axial conduction.Moreover,the influence of the adiabatic boundary condition on the cold and hot ends of separating plate of PFHE was transferred to the inner domain of PFHE by axial conduction effect,which resulted in the fluid temperature distortion in near-inlet domain.When the boundary conditions of constant wall temperature or constant heat flux were adopted on hot and cold ends of separating plate respectively,the fluid temperature distortion in near-inlet domain almost disappeared.When considering axial heat conduction,compared with the adiabatic boundary conditions at both ends of the partition,the effectiveness of the constant wall temperature boundary conditions increases by 35.8%(εc)and 31.7%(εh),and the effectiveness of the constant heat flow boundary conditions increases by 22.8%(ε).
关 键 词:热边界条件 板翅换热器 轴向导热 隔板冷端 隔板热端 有效度
分 类 号:TK124[动力工程及工程热物理—工程热物理]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.13