减小电镦下沉深度与混晶改善的增材调控研究  

Study on Additive Control of Reducing the Depth of Electric Upsetting Settling and Mixed-crystal Improvement

作　　者：戴魏魏 蒋立鹤 权国政[2] 余炎泽 DAI Wei-wei;JIANG Li-he;QUAN Guo-zheng;YU Yan-ze(COSCO Shipping Marine Equipment&Apares(NanJing)Co.,Ltd,China COSCO Shipping Corporation Limited,Nanjing 211121,China;College of Material Science and Engineering,Chongqing University,Chongqing 400044,China)

机构地区：[1]南京中远海运船舶设备配件有限公司,南京211121 [2]重庆大学材料科学与工程学院,重庆400044

出　　处：《内燃机与配件》2021年第9期109-110,共2页Internal Combustion Engine & Parts

基　　金：重庆市基础研究与前沿探索项目(cstc2018jcyjAX0459)。

摘　　要：在电镦成型时,尤其是大型件的成型时,为了获得所要求的“蒜头”直径,往往会造成坯料前端的下沉缺陷。下沉缺陷的存在,一方面,大的下沉深度会使坯料端面晶粒分布极其不均匀,出现混晶;另一方面使坯料在后续的模锻成型时出现闭气问题。通过增材调控的方法,不仅能使下沉深度减小,而且可以使电镦端面的混晶区域的晶粒趋于均匀化,大大提升了电镦件的质量。In the process of electric upsetting forming,especially in the forming of large workpiece,to obtain the required"bulb"diameter,the sink defect of the front end of the billet is often caused.The existence of subsidence defects,on the one hand,large subsidence depth will make the end surface of the billet grain distribution is extremely uneven,mixed crystal;On the other hand,the billet is closed in the following forging process.By means of control of additive,not only the sinking depth can be reduced,but also the grains in the mixed crystal area of the electric upsetting end face tend to be uniform,which greatly improves the quality of the electric upsetting workpiece.

关 键 词：增材调控 下沉深度 混晶 电镦 

分 类 号：TG316[金属学及工艺—金属压力加工]