检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:陈丽霞 上官诚江 黄纯熙 陈润欣 张国平 CHEN Li-xia;SHANGGUAN Cheng-jiang;HUANG Chun-xi;CHEN Run-xin;ZHANG Guo-ping(Fuzhou Power Supply Company,State Grid Fujian Electric Power Co.,Ltd,Fuzhou 350007,China;Fujian Nebula Electronics Co.,Ltd,Fuzhou 350007,China)
机构地区:[1]国网福建省电力有限公司福州供电公司,福建福州350007 [2]福建星云电子股份有限公司,福建福州350007
出 处:《电工电气》2021年第6期38-42,共5页Electrotechnics Electric
摘 要:小电阻接地方式可有效降低过电压和提高故障选线率,但在小电阻改造过渡期间存在并列转供电等问题。通过对一次接线方式进行分析,在小电阻接地变高压侧与主变低压侧间加装专用开关。对改造后的运行方式进行继电保护分析并提出相应的二次应对措施及过渡方案,实际应用案例表明,新方案有效提高了配电网小电阻接地改造期间的供电可靠性。Small resistance grounding method can effectively reduce overvoltage and improve fault line selection rate,but there are some problems during the transition of small resistance transformation,such as parallel to power supply.Through the analysis of the primary wiring mode,a special switch is installed between the high voltage side of the small resistance grounding transformer and the low voltage side of the main transformer.Relay protection analysis is carried out on the operation mode after transformation and corresponding secondary countermeasures and transition schemes are put forward,and the practical application shows that the new scheme can effectively improve the reliability of power supply during the transformation of small resistance grounding in distribution network.
分 类 号:TM862[电气工程—高电压与绝缘技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.49