检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:谢霜彦 徐钧 彭良明[1] XIE Shuangyan;XU Jun;PENG Liangming(CAS Key Laboratory of Mechanics Behavior and Design of Materials,Department of Modern Mechanics,University of Science and Technology of China,Hefei 230027,Anhui,China)
机构地区:[1]中国科学技术大学近代力学系,中科院材料力学行为和设计重点实验室,安徽合肥230027
出 处:《实验力学》2021年第4期480-490,共11页Journal of Experimental Mechanics
基 金:国家自然科学基金(No.11572306)。
摘 要:高熵合金因具有优异的力学性能及广阔的组元选配空间而日益受到关注。本文研究了亚稳态Fe_(38-x)Mn_(30)Co_(15)Cr_(15)Ni_(2)Gd_(x)(x=0,0.1,0.2)高熵合金在不同预应变准静态压缩过程中由塑性诱发的面心立方(face-centered cubic,FCC)向密排六方(hexagonal close-packed,HCP)的相转变行为,测定了FCC相和HCP相的纳米压痕硬度和弹性模量,在此基础上比较研究了其室温微蠕变变形特性。结果表明,增加Gd含量和压缩预应变可促进相变,硬质HCP相的纳米压痕硬度和弹性模量显著高于FCC相;Gd的添加可提高未预压缩单相FCC合金的抗蠕变能力,相同压缩预应变下,含Gd合金经预压缩后FCC相、HCP相在相同载荷下的蠕变速率明显降低,且后者表现出更优的抗蠕变特性。对高熵合金组元进行非等原子比设计,通过塑性诱发相变引入新的固溶体相,可为提高合金的综合力学性能尤其是蠕变抗力提供有价值的技术途径。High entropy alloys(HEAs)have attracted increasing attention due to their excellent mechanical properties and broad space for component selection.The present study investigated plasticity-induced face-centered cubic(FCC)to hexagonal close-packed(HCP)phase transformation behavior of metastable Fe_(38-x)Mn_(30)Co_(15)Cr_(15)Ni_(2)Gd_(x)(x=0,0.1,0.2)HEAs after subjected to compressive deformation with different strains.Nanoindentation hardness and elastic modulus of the FCC and HCP phases were examined.A comparison was conducted for room temperature micro-creep deformation characteristics of the two solid solution phases.The results show that the phase transformation is promoted via increasing Gd content and compression pre-strain.The formed hard HCP phase exhibits much higher nanoindentation hardness and elastic modulus than those of the FCC phase.Gd addition improves creep resistance of the single-phase FCC alloy without pre-compression and simultaneously leads to a remarkable reduction in creep strain rates at a given load of the FCC and HCP phases under an identical compression pre-strain.Moreover,the HCP phase shows a higher creep resistance,which implies that introducing a new solid solution phase via plastic deformation in non-equiatomic metastable HEAs is an practical technological approach to enhance their comprehensive mechanical properties,especially the resistance against creep deformation.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.49