基于Moldflow的抽屉塑件注塑过程模流分析与优化  

Mold Flow Simulation and Optimization for a Drawer Plastic Part DuringInjection Molding Based on Moldflow

作　　者：王威舒 张伟[1,2] 刘涛 朱洪斌 WANG Weishu;ZHANG Wei;LIU Tao;ZHU Hongbin(School of Mechanical Engineering and Automnation,Dalian Polytechnie Universily,Dalian 116034,China;Dalian Jirui Tool Technology Co.Ltd.,Dalian 116113,China)

机构地区：[1]大连工业大学机械工程与自动化学院,辽宁大连116034 [2]大连吉瑞刀具技术股份有限公司,辽宁大连116113

出　　处：《铸造技术》2021年第8期722-726,共5页Foundry Technology

摘　　要：以Moldflow软件为基础,对抽屉模型进行一模两腔布局和有限元网格划分,并完成模流分析与优化。结果表明,通过多次比对与参数优化调整,最终确立一套合理的浇注系统方案,提高了产品生产效率,减少生产缺陷,缩短生产的周期。Based on the software Moldflow,the layout of the drawer model with one mode and two cavities and the mesh division of the finite element were carried out,and the Moldflow analysis and optimization were completed. The results show that through multiple comparison and parameter optimization adjustment,a set of reasonable gating system scheme is finally established,which improves the production efficiency,reduces production defects and shortens the production cycle.

关 键 词：抽屉 一模两腔 模流分析 优化设计 

分 类 号：TQ320[化学工程—合成树脂塑料工业]