检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:赵嫚[1] 高汉根 ZHAO Man;GAO Han-gen(School of Petrochemical Engineering,Lanzhou University of Technology,Lanzhou 730050,China)
机构地区:[1]兰州理工大学石油化工学院,甘肃兰州730050
出 处:《压缩机技术》2021年第4期10-13,共4页Compressor Technology
基 金:国家自然基金项目(51265026)。
摘 要:基于ANSYS Workbench软件对某卧式涡旋压缩机转子系统三维模型模态分析,获取转子系统前六阶模态的固有频率、振型以及临界转速;应用瞬态不平衡响应分析法对该转子系统在变转速工况下(尤其启动时)运行、不平衡质量产生离心力的变化问题进行分析。分析结果表明:临界转速在工作转速0~6000 r/min范围内没有出现转子系统最大变形出现位于平衡铁外边缘处,变形量为3.8698e-3 mm。依据旋转机械标准振动评价等级ISO-10816,转子系统振动状态良好,工作平稳运行。Based on ANSYS Workbench software,the modal analysis of the three-dimensional model for a horizontal scroll compressor rotor system is carried out,and the natural frequency,vibration modes and critical speed of the first six modes of rotor system are obtained.The transient unbalance response analysis method is applied to the rotor system under variable speed conditions(especially at start-up),the problem of centrifugal force changes caused by unbalanced masses is analyzed.The analysis results show that the critical speed does not appear in the range of 0~6000 r/min.The maximum deformation of rotor system occurs at the outer edge of balance iron,and the deformation is 3.8698e-3 mm.According to the vibration evaluation level specifiedin ISO 10816,the rotor system is in good vibration state and runs smoothly.
关 键 词:涡旋压缩机 转子系统 模态分析 临界转速 瞬态动力学
分 类 号:TH45[机械工程—机械制造及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222