砂级配和含泥量对机喷抹灰砂浆性能的影响研究  

Study the effect of particle size distribution and mud content of sands on the performance of machine sprayed plastering mortar

作　　者：陈友治[1] 王云 陈洪涛 徐明 CHEN Youzhi;WANG Yun;CHEN Hongtao;XU Ming(State Key Laboratory of Silicate Materials for Architectures,Wuhan University of Technology,Wuhan 430070,China;Shanghai YuTong Building Technology Co.Ltd.,Shanghai 201900,China;China Construction Fifth Bureau Third Construction Co.Ltd.,Changsha 410116,China;Qingzhou China United Cement Co.Ltd.,Weifang 262500,China)

机构地区：[1]武汉理工大学硅酸盐建筑材料国家重点实验室,湖北武汉430070 [2]上海宇砼建筑科技股份有限公司,上海201900 [3]中建五局第三建设有限公司,湖南长沙410116 [4]青州中联水泥有限公司,山东潍坊262500

出　　处：《新型建筑材料》2021年第9期70-73,共4页New Building Materials

摘　　要：研究了砂级配和含泥量对机喷抹灰砂浆力学性能和可施工性能的影响。结果表明:砂的细度模数对机喷抹灰砂浆的压折比影响不明显,但对砂浆的拉伸粘结强度影响较大,砂的细度模数应控制在2.1~2.5。含泥量过大对砂浆的工作性能和力学性能均有较大的负面影响,当含泥量为8%时,砂浆的拉伸粘结强度较含泥量为0时降低了30.2%。建议机喷抹灰砂浆制备时宜控制砂的含泥量不高于4%。In this study,the effect of particle size distribution and mud content of sands on the mechanical and constructability properties of sprayed plastering mortar were investigated.The results showed that there was seldom correlation between the ratio of compressive strength to flexural strength and sand fineness modulus.While,the fineness modulus of sand was controlled at 2.1~2.5,a great correlation between tensile bond strength and the fineness modulus was found.It was showed that excessive mud content had a great negative impact on the working and mechanical properties of mortar,when the mud content was 8%,the tensile bond strength decreased 30.2% compared to that without mud,it was suggested that the mud content of sand should not be higher than 4% during the preparation of sprayed plastering mortar.

关 键 词：砂细度模数 砂含泥量 机喷抹灰砂浆 可施工性 

分 类 号：TU578.1[建筑科学—建筑技术科学]