增密对少分枝大豆品种光合特性和产量形成的影响  被引量:7

Effects of Close Planting on Photosynthetic Characteristics and Yield of Less Branched Soybean Varieties

在线阅读下载全文

作  者:李瑞东 徐彩龙 尹阳阳 宋雯雯[2] 孙石[2] 韩天富[2] 吴存祥[2] 胡水秀 LI Rui-dong;XU Cai-long;YIN Yang-yang;SONG Wen-wen;SUN Shi;HAN Tian-fu;WU Cun-xiang;HU Shui-xiu(College of Agriculture,Jiangxi Agricultural University/Key Laboratory of Crop Physiology,Ecology and Genetic Breeding,Ministry of Education/Jiangxi Key Laboratory of Crop Physiology,Ecology and Genetic Breeding/Southern Regional Collaborative Innovation Center for Grain and Oil Crops in China,Nanchang 330045,China;Institute of Crop Sciences,Chinese Academy of Agricultural Sciences/National Soybean Industrial Technology R&D Center,Beijing 100081,China)

机构地区:[1]江西农业大学农学院/作物生理生态与遗传育种教育部重点实验室/江西省作物生理生态与遗传育种重点实验室/南方粮油作物协同创新中心,江西南昌330045 [2]中国农业科学院作物科学研究所/国家大豆产业技术研发中心,北京100081

出  处:《大豆科学》2021年第5期633-642,共10页Soybean Science

基  金:国家重点研发计划(2020YFD1000903)。

摘  要:为深入分析在农业机械水平提高、精量播种技术提升背景下应运而生的少分枝大豆品种对密度增加的响应情况,探讨其最适播种密度,优化大豆栽培模式,以2个不同分枝类型的品种(少分枝中作XA12938和多分枝中黄13)为供试材料,于2018—2019年,设置6个种植密度(13.5万,18.0万,22.5万,27.0万,31.5万和36.0万株·hm^(-2)),研究增密种植条件下不同分枝类型品种光合特性变化和产量差异。结果表明:(1)冠层光截获率随种植密度的增加而增加,增至27万株·hm^(-2)时趋于稳定,与中黄13相比,中作XA12938关键时期冠层光截获率提高4.90%。(2)SPAD随密度的增加而增大,且高密度处理(31.5万和36.0万株·hm^(-2))下SPAD最大值可提前至R3期出现,此外,与中黄13相比,中作XA12938 SPAD高值持续期较长。(3)Fv/Fm随种植密度的增加而降低,中黄13高密度处理降低幅度(5.10%)大于中作XA12938(3.51%)。被动耗散占比Y(NO)中作XA12938与中黄13相比,处理间随密度增大而增加幅度较小,极值出现晚。(4)中作XA12938和中黄13最大净光合速率分别为30.46和24.34μmol·m^(-2)·s^(-1),且随种植密度增加,中作XA12938净光合速率降幅(17.73%)小于中黄13(22.51%),各密度条件下中作XA12938净光合速率表现均存在优势。(5)随种植密度增加大豆产量总体先增加后趋平,当种植密度大于18.0万株·hm^(-2)时即可达到增产效果。中作XA12938产量潜力更高,且耐密植能力更强。综合分析说明,增加种植密度有利于提高大豆光能利用效率,尽管大豆单株光合能力下降,但少分枝品种单株净光合速率和Fv/Fm在增密条件下降幅更小且稳定性较强。少分枝品种中作XA12938产量潜力较高,且密植条件下叶片持绿性强,冠层光能截获率和叶片净光合能力增强,被动耗散占比增幅较小,有利于光能资源利用,可在高密度种植条件下稳定增产。因此,生产中可选用密植时光合特性较稳定的少分枝In order to investigate the response of less branched soybean varieties to increased density in the context of improved agricultural machinery and precision sowing technology,to explore their optimum sowing density and to optimize soybean cultivation patterns,this study used two varieties with different branching types(less branched variety Zhongzuo XA12938 and more branched variety Zhonghuang 13)as test materials and planted at six densities(1.35×10^(5),1.80×10^(5),2.25×10^(5),2.70×10^(5),3.15×10^(5) and 3.60×10^(5) plants·ha^(-1))from 2018 to 2019.The planting densities(1.80×10^(5),2.25×10^(5),2.70×10^(5),3.15×10^(5) and 3.60×10^(5) plants·ha^(-1))were used to study the photosynthetic characteristics and yield differences between varieties with different branching types under close planting conditions.(1)Canopy light interception rate increased with increasing planting density and stabilized at 2.70×10^(5) plants·ha^(-1),with 4.90%higher light interception in the canopy during the critical period in Zhongzuo XA12938 compared to Zhonghuang 13.(2)The SPAD increased with increasing density and the highest SPAD values could occur earlier up to the R3 stage at high density treatments(3.15×10^(5) and 3.60×10^(5) plants·ha^(-1)).In addition,the high SPAD values lasted longer in Zhongzuo XA12938 compared to Zhonghuang 13.(3)Fv/Fm decreased with increasing planting density,and the decrease was greater for Zhonghuang 13(5.10%)high density treatments than for Zhongzuo XA12938(3.51%).The photodamage percentage Y(NO)of Zhongzuo XA12938 increases less with increasing density between treatments and the maximum value occured later compared to the photodamage percentage Y(NO)of Zhonghuang 13.(4)The maximum net photosynthetic rates of Zhongzuo XA12938 and Zhonghuang 13 were 30.46 and 24.34μmol·m^(-2)·s^(-1),respectively,and the decrease in net photosynthetic rate with increasing planting density was smaller in Zhongzuo XA12938(17.73%)than in Zhonghuang 13(22.51%),with Zhongzuo XA12938 showing an advantage in

关 键 词:大豆 密植 少分枝 光合特性 产量 

分 类 号:S565.1[农业科学—作物学]

 

参考文献:

正在载入数据...

 

二级参考文献:

正在载入数据...

 

耦合文献:

正在载入数据...

 

引证文献:

正在载入数据...

 

二级引证文献:

正在载入数据...

 

同被引文献:

正在载入数据...

 

相关期刊文献:

正在载入数据...

相关的主题
相关的作者对象
相关的机构对象