检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:茅鸣 童科挺 张家亮[2] 王建民[2] 李玉顺 MAO Ming;TONG Keting;ZHANG Jialiang;WANG Jianmin;LI Yushun(College of Civil Engineering&Architecture,Qingdao Agricultural University,Qingdao 266109,China;School of Civil and Environmental Engineering,Ningbo University,Ningbo 315211,China)
机构地区:[1]青岛农业大学建筑工程学院,山东青岛266109 [2]宁波大学土木与环境工程学院,浙江宁波315211
出 处:《建筑材料学报》2021年第6期1280-1290,共11页Journal of Building Materials
基 金:国家自然科学基金资助项目(51978345,51678310);浙江省自然科学基金资助项目(LQ19E080007);宁波市科技计划项目(202002N3090)。
摘 要:为研究钢-竹组合工字形梁经历长期荷载作用后的力学性能,以竹胶板厚度、钢板厚度、含钢率为参数设计2组共12个试件,其中一组经过1 a的长期荷载作用后进行受弯破坏试验,另一组直接进行短期受弯试验,对比研究长期荷载作用对组合梁极限承载力衰减、挠度变形、构件延性、截面应变等方面的影响;同时基于有效惯性矩法对组合梁破坏时的挠度进行计算分析.结果表明:组合梁破坏试验现象与其含钢率有关,一般表现为下翼缘竹胶板脱胶开裂,随着含钢率的增加,组合梁破坏范围逐渐向上部扩散;长期加载后,组合梁延性发生改变;竹胶板长期受拉或受压对组合梁的影响基本相同,组合梁中性轴位置未发生改变;组合梁极限承载力衰减程度与竹胶板厚度、钢板厚度、含钢率均有关;由挠度计算公式得到的计算值与试验值吻合较好,误差均在10%以内.In order to study the mechanical properties of steel⁃bamboo combination I⁃beams under long⁃term load,thickness of bamboo plywood,thickness of steel plate,and steel content were set as the main parameters to design two sets of 12 specimens.One group was subjected to a bending failure test after a one⁃year long⁃term load,and the other was directly subjected to a short⁃term bending test.The long⁃term effects of load on the ultimate bearing capacity attenuation,deflection,component ductility,and section strain of combination beams were studied.The deflection of combination beams at failure was calculated and analyzed based on the effective moment of inertia method.The results show that the failure test phenomenon of combination beams is related to the steel content,which is generally manifested as debonding and cracking of the lower flange bamboo plywood.The damage range of the combination beams gradually spread upward as the steel content increased.Ductility of combination beams changed after long⁃term loading.The effect on the combination beams is basically the same after long⁃term tension and compression of bamboo plywood,and the position of the neutral axis of combination beams remaines unchanged.The degree of bearing capacity attenuation is related to the thickness of bamboo plywood,steel plate thickness,and steel content.The calculated values obtained from the deflection calculation formula agree well with the experimental values,and the errors are all within 10%.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117