CTAB-SDS复配体系制备SiO_(2)气凝胶及其性能研究  

Preparation and Properties of SiO_(2) Aerogels by CTAB-SDS Compound System

作　　者：郭靖雯 刘源[1] 张娜[1] GUO Jing-wen;LIU Yuan;ZHANG Na(College of Science,University of Shanghai for Science and Technology,Shanghai 200093,China)

机构地区：[1]上海理工大学理学院,上海200093

出　　处：《广州化学》2021年第6期31-36,共6页Guangzhou Chemistry

摘　　要：以碱性硅溶胶为前驱体,去离子水为唯一溶剂,通过酸-碱两步催化和常压干燥工艺,仅用一天时间制备出了SiO_(2)气凝胶。在制备过程中,将十六烷基三甲基溴化铵(CTAB)和十二烷基硫酸钠(SDS)进行复配,减小了蒸发干燥时水的毛细管张力,减小了其对气凝胶结构的破坏。结果表明,当SDS与CTAB的摩尔比为0.5时,经450℃热处理得到的SiO_(2)气凝胶具有最小的密度209 mg/cm^(3)、最低的室温热导率0.036 W/(m‧K)和最高的比表面积409 m^(2)/g。本文提出的制备方法降低了生产成本,简化了生产工艺,缩短了制备时间,有利于SiO_(2)气凝胶的大批量工业化生产和使用。In this paper,using alkaline silica sol as precursor and the deionized water as the only solvent,SiO_(2) aerogel was prepared in only one day by the two-step acid-base catalyzed approach and ambient pressure drying.In the preparation process,the cetyltrimethylammonium bromide(CTAB)and the sodium dodecyl sulfate SDS were added to reduce the surface tension of water during the drying process,and reducing the shrinkage and cracking of the samples.When the molar ratio of SDS to CTAB was 0.5,the obtained silica aerogel showed the minimum density of 209 mg/cm^(3).The lowest thermal conductivity of 0.036 W/(m‧K)and the highest specific surface area of 409 m^(2)/g after heat treatment at 450℃.The preparation method proposed in this work reduces the production cost,simplifies the production process and shortens the preparation time,which is conducive to the large-scale industrial production and application of SiO_(2) aerogel.

关 键 词：硅溶胶 表面活性剂 常压干燥 二氧化硅气凝胶 

分 类 号：O648[理学—物理化学]