Longwall top coal caving design for thick coal seam in very poor strength surrounding strata  

作　　者：H.Jangara C.Atilla Ozturk 

机构地区：[1]Mining Engineering Department,Faculty of Mines,Istanbul Technical University,Istanbul,Turkey

出　　处：《International Journal of Coal Science & Technology》2021年第4期641-658,共18页国际煤炭科学技术学报（英文）

摘　　要：Alpu lignite field is an important coal deposit with nearly 2 billion tons of coal resources located in the middle of Turkey.The mine deposit consists of three main seams.The thickness of two of them vary from 4 to 30 m.The surrounding rock mass is very poor in terms of strength.The high clay content and weak rock mass make mechanized mining difficult.In this research,applicability of the longwall top coal caving method was investigated.The very weak strength behavior of the coal and the surrounding strata increases the importance of research in the mine site in terms of ground control.The aim is to design the mechanized longwall mine based on ground control principles.First of all,classification of the roof,coal,inter-burden,and floor strata were classified based on geotechnical aspects.Then,cavability index,shield,and floor bearing capacity were investigated.Different methods were applied to understand the limitations of a mechanized system that is very critical due to the very low strength strata.According to the main results,roof strata was classified as immediately caving while mining height was calculated as 5-6 m.Finally,the relations among geotechnical characterizations of roof and floor strata,cutting and caving heights,and required shield capacity were presented based on analytical and numerical applications.The proposed approach can be used as a ground control method for the applicability as well as the limitations of mechanized longwall mining design in weak strata conditions.

关 键 词：Coal GEOTECHNICS Ground control Longwall mining Numerical methods 

分 类 号：TD823.4[矿业工程—煤矿开采]