检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:Toshizaemom Noce Sérgio de Morais Hanriot Luis Carlos Monteiro Sales JoséRicardo Sodré Matheus Bitarães de Novaes
机构地区:[1]Department of Mechanical Engineering,Pontifical University of Minas Gerais,Av.Dom JoséGaspar 500,Belo Horizonte,MG 30535-901,Brazil [2]School of Engineering&Applied Science,Aston University,Aston Triangle,Birmingham B47ET,UK [3]Department of Electrical Engineering,Federal University of Minas Gerais,Av.Pres.Antônio Carlos,6627,Belo Horizonte,MG 31270-901,Brazil
出 处:《Automotive Innovation》2020年第2期169-180,共12页汽车创新工程(英文)
基 金:The authors thank Brazilian Development BNDES for the economic support,the Joint Research Centre JRC for the technical assistance to this project and to Mr.Adam Aslam/Gabriel Santos for the grammar revision.
摘 要:A precise energy conversion factor is required to define the impact of greenhouse gas emissions by gasoline-powered vehi-cles and policies that will guide the application of future eco-innovations.The current energy conversion factor adopted by many countries is based on the Willans line approach,initially proposed in 1888 for steam engines,later adapted for internal combustion engines.The actual energy conversion factor,which defines the energy conversion for drivers in real traffic,is missing.In this article,eight world-class engines are tested in an engine bench for the acquisition of specific fuel consumption 3D maps.Then,their energy conversion factors,calculated by dividing the energy output by the energy input,are simulated in real and urban traffic,acquired according to the real driving emissions(RDE)cycle.In addition,a reference vehicle is instrumented to measure the energy input(fuel flow)and the energy output(mechanical energy in the half axles)under the same RDE cycle standards.The results of both procedures are very similar,respectively,0.405±0.04 L/kWh for the simulation based on eight benchmark engines,and 0.392±0.04 L/kWh for the reference vehicle driven in RDE traffic conditions,with a 95%confidence interval.For turbocharged engines,the factor attained by the simulation is 0.395±0.04 L/kWh.The values of the energy conversion factor for gasoline engines got in this research are higher than those obtained through the Willans line approach,suggesting a new standard value of 0.405 L/kWh,replacing the current 0.264 L/kWh.It could substantially change the greenhouse gas emissions in a tank-to-wheel approach for the entire vehicle and add-on eco-innovations.
关 键 词:Energy conversion factor Willans line EC443 ECO-INNOVATION CO_(2)emission
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.62