220t/h锅炉烟气侧耦合垃圾焚烧数值模拟  

Numerical simulation of flue gas side coupled municipal solid waste incineration in a 220t/h boiler

作　　者：史兵权 史明哲 张睿 SHI Bingquan;SHI Mingzhe;ZHANG Rui(School of Energy and Power Engineering,Nanjing University of Science and Technology,Nanjing 210094,China;Zibo Chenyue Baoshan Environmental Protection Technology Co.,Ltd.,Zibo 255100,China)

机构地区：[1]南京理工大学能源与动力工程学院,江苏南京210094 [2]淄博晨越宝山环保科技有限公司,山东淄博255100

出　　处：《洁净煤技术》2022年第3期150-158,共9页Clean Coal Technology

基　　金：国家重点研发计划资助项目(2020YFC1910000);中央高校基本科研业务费专项资金资助项目(30919012104)。

摘　　要：燃煤耦合垃圾焚烧发电技术可充分利用现有的燃煤机组和环保设施协同处理垃圾,降低垃圾发电成本,提高垃圾处理规模,降低存量煤电煤耗,提高非化石能源利用比例。目前燃煤耦合垃圾焚烧发电技术中耦合方式主要有:烟气侧耦合、燃料侧耦合和蒸气侧耦合3种。为研究烟气侧燃煤耦合垃圾焚烧发电技术,以220 t/h四角切圆煤粉锅炉为研究对象,提出了烟气侧燃煤耦合垃圾焚烧改造方案。其中改造前系统煤粉炉中煤粉单独燃烧,占总输入热量的100%,而改造后系统中垃圾热量替代总输入热量的5%和10%,而煤粉占总输入热量的95%和90%。利用Fluent数值模拟软件对改造前后的3种燃烧工况分别进行数值模拟。数值模拟结果表明:烟气侧耦合改造会使锅炉流场工况更加复杂,且垃圾替代燃煤热量比例越高影响越明显;炉膛截面平均温度分布受耦合烟气量的影响;出口截面烟气平均温度随垃圾替代燃煤热量比例的增加而升高,其中改造前煤粉单独燃烧时烟气出口温度为1366.9 K,改造后5%垃圾替代燃煤热量系统的烟气出口平均温度升高到1409.9 K,10%时烟气出口平均温度升高到1420.1 K;炉膛出口处NO浓度随垃圾替代燃煤热量比例的增加而升高,相比于改造前煤粉单独燃烧,改造后5%垃圾替代燃煤热量系统的NO排放浓度增加了6.3%,10%替代时增加了13.0%;炉膛出口处SO_(2)浓度随垃圾替代燃煤热量比例的增加而降低,相比改造前,改造后5%垃圾替代燃煤热量系统的SO_(2)浓度降低40.9%,10%比例时降低41.4%。The technology of coal fired coupled waste incineration power generation can make full use of the existing coal fired units and environmental protection facilities,co-processing waste,reduce waste-to-energy costs,improve the scale of waste treatment,and reduce the coal consumption of coal fired power,increase the proportion of non-fossil energy utilization.At present,there are three coupling modes in coal-fired coupled waste incineration power generation technology:flue gas side coupling,fuel side coupling and steam side coupling.In order to study the coupled incineration power generation technology,a coupling transformation scheme based on a 220 t/h tangentially pul⁃verized coal boiler was proposed.Among them,the pulverized coal in the pulverized coal boiler of the system before transformation is burn⁃ed alone,accounting for 100%of the total input calorific,and after the transformation,the waste calorific replaces 5%and 10%of the total input calorific,while the pulverized coal accounts for 95%and 90%of the total input calorific.The combustion conditions before and after the transformation were analyzed by Fluent simulated.The results show that the flue gas side coupling transformation will make the boiler flow field more complex,and the higher the proportion of waste replacing coal calorific is,the more obvious the impact is;the average tem⁃perature of the furnace section is affected by the coupled flue gas volume.The average flue gas temperature at the outlet section increases with the increase of the calorific ratio of waste to coal.The flue gas outlet temperature is 1366.9 K when pulverized coal is burned alone before the transformation.After the transformation,the average flue gas outlet temperature of the 5%waste to coal calorific ratio system in⁃creases to 1409.9 K,and the average flue gas outlet temperature increases to 1420.1 K when 10%;the NO concentration at the furnace outlet increases with the increase of the calorific proportion of waste replacing coal.Compared with the separate combustion o

关 键 词：烟气侧耦合 垃圾焚烧 煤粉锅炉 燃煤发热量 

分 类 号：TK16[动力工程及工程热物理—热能工程] TK223