检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:徐日荣[1] 陈湘瑜[1] 陈昊 张玉梅[1] 蓝新隆[1] 唐兆秀[1] Xu Rirong;Chen Xiangyu;Chen Hao;Zhang Yumei;Lan Xinlong;Tang Zhaoxiu(Institute of Crop Sciences,Fujian Academy of Agricultural Sciences/Fujian Engineering Research Center for Characteristic Upland Crops Breeding,Fuzhou,350013,China)
机构地区:[1]福建省农业科学院作物研究所/福建省特色旱作物品种选育工程技术研究中心,福州市350013
出 处:《中国农机化学报》2022年第5期22-28,共7页Journal of Chinese Agricultural Mechanization
基 金:福建省属公益类科研院所基本科研专项(2019R1031—12、2018R1026—8);福建省农业科学院科技创新团队(CXTD2021008—3)。
摘 要:为明确福建省花生的果柄节点强度情况,快速推动花生收获机械应用,对经省级认定的8个花生品种果柄节点强度进行测定。分析表明8个花生品种果柄节点强度在1.2~25.8 N之间,强度大于5 N的占97.33%,平均值为10.7 N。品种间果柄节点强度存在显著差异,其中福花4号的果柄节点强度均值最大,为11.40 N,莆花2号果柄节点强度最小,均值为9.91 N。品种和荚果饱满度互作存在极显著差异,大部分品种饱果果柄节点强度大于秕果。随着花生成熟,花生果柄节点强度极显著的减弱。覆膜和浇水可以提高花生果柄节点强度,但与露地栽培处理没有显著差异。果柄含水量与果柄节点强度存在极显著负相关。结果表明8个品种均适合花生联合收获机收获,为了减少机收造成的落果损失,对果柄节点强度较小的品种可以采取提前收获,或采用覆膜和浇水,在成熟中后期,减少田间土壤湿度,减少果柄含水量,以提高果柄节点强度。In order to determine the peg strength of peanut varieties and promote the application of peanut mechanical harvesting in Fujian Province,the peg strength of 8 recognized varieties was tested.The result showed that the peg strength was between 1.2-25.8 N,with an average of 10.7 N,and more than 5 N accounted for 97.33%.The peg strength showed significant differences among different varieties.The average peg strength of Fuhua 4 was the largest(11.40 N),while that of Puhua 2 was the smallest(9.91 N).There were also significant differences between variety and pod plumpness,and the peg strength of full pod of most cultivars was greater than that of immature pod.The peg strength decreased significantly with increasing maturity of peanuts.Film mulching and watering improved the strength of peanut peg,but there was no significant difference with the open field treatment.There was a significant negative correlation between the water content of peg and the peg strength.Results showed that the 8 varieties were suitable for peanut combine harvesting.In order to reduce the fruit loss caused by mechanical harvesting,the varieties with small peg strength can be used during early harvest,or use film mulching and watering treatment,and reduce the soil humidity and water content of the peg in the middle and late stages of maturity.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.7