检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:熊钰[1] 傅希桐 李骞 孙泽威 张春 张飞 XIONG Yu;FU Xitong;LI Qian;SUN Zewei;ZHANG Chun;ZHANG Fei(State Key Laboratory of Oil&Gas Reservoir Geology and Exploitation,Southwest Petroleum University,Chengdu 610500,China;Exploration and Development Research Institute,PetroChina Southwest Oil&Gas Field Company,Chengdu 610041,China)
机构地区:[1]西南石油大学油气藏地质及开发工程国家重点实验室,成都610500 [2]中国石油西南油气田公司勘探开发研究院,成都610041
出 处:《石油勘探与开发》2022年第3期538-547,共10页Petroleum Exploration and Development
基 金:中国石油-西南石油大学创新联合体项目“深层/超深层碳酸盐岩天然气勘探开发基础理论与关键技术研究”(2020CX010401)。
摘 要:采用超细铜管模拟碳酸盐岩地层中微裂缝,开展低速流动实验,分析气体在不同缝高裂缝中的流动状态变化,确定流动状态转换界限及转换区间,建立流动状态转换界限计算方法。研究表明,气体在缝高较大裂缝中的流动形式以理想的哈根-泊肃叶流动为主。由于缝高的减小,气体在裂缝中的流动从以理想光滑缝面的哈根-泊肃叶流动为主向非哈根-泊肃叶流动为主转换,转换的临界点即为流动状态转换界限。裂缝缝高在流动状态转换缝高界限以下继续减小到一定程度后,气体流动形式逐渐向理想的达西流动转换,从而可以确定裂缝在闭合过程中流动状态的转换区间。综合裂缝面的三维微凸体扫描结果、裂缝的材料性质及流体性质,建立了流动状态转换界限计算方法。实验测试和理论计算表明:从管流到达西流的缝高界限约为裂缝上、下两面微凸体最大高度之和的2倍。Low-speed flow experiments in which ultra-fine copper tubes are used to simulate micro-fractures in carbonate strata are conducted to analyze the variations of gas flow state in fractures of different fracture heights,determine flow state transition limit and transition interval,and establish the calculation method of flow state transition limit.The results show that the ideal Hagen-Poiseuille flow is the main form of gas flow in large fractures.Due to the decrease of fracture height,the gas flow in the fracture changes from Hagen-Poiseuille flow with ideal smooth seam surface to non-Hagen-Poiseuille flow,and the critical point of the transition is the boundary of flow state transition.After the fracture height continues to decrease to a certain extent below the boundary of the flow state transition fracture height,the form of gas flow gradually changes to the ideal Darcy flow,thus the transition interval of the gas flow state in the closing process of fracture can be determined.Based on the three-dimensional microconvex body scanning of the fracture surface,the material properties of fracture and properties of fluid in the fracture,a method for calculating the boundary of flow state transition is established.The experimental test and theoretical calculation show that the limit of the fracture height for the transition from pipe flow to Darcy flow is about twice the sum of the maximum height of the microconvex bodies on the upper and lower sides of the fracture.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.7