几种常用炸药的爆压与爆轰反应区精密测量  

Accurate measurements of detonation pressure and detonation reaction zones of several commonly-used explosives

作　　者：舒俊翔 裴红波 黄文斌[1] 张旭[1] 郑贤旭[1] SHU Junxiang;PEI Hongbo;HUANG Wenbin;ZHANG Xu;ZHENG Xianxu(Institute of Fluid Physics,China Academy of Engineering Physics,Mianyang 621999,Sichuan,China)

机构地区：[1]中国工程物理研究院流体物理研究所,四川绵阳621999

出　　处：《爆炸与冲击》2022年第5期14-23,共10页Explosion and Shock Waves

基　　金：国家自然科学基金(11602248);科学挑战专题(TZ2018001)。

摘　　要：为了获得几种常用炸药的爆压和反应区宽度数据,采用激光干涉测试技术对TNT、PETN、RDX、HMX、TATB和CL-20炸药的稳态爆轰波界面粒子速度进行了测试,获得了高精度的界面粒子速度时程曲线,利用阻抗匹配公式计算得到了炸药的爆压。结果表明:PETN、RDX、HMX和CL-20等理想炸药的界面粒子速度曲线存在较明显的拐点,爆轰反应区较窄,反应时间为7~15 ns。TNT和TATB炸药由于存在碳凝聚慢反应过程,界面粒子速度曲线没有明显的拐点,爆轰反应时间分别为(100±15)ns和(255±20)ns。初步的不确定度分析表明,激光干涉法测试爆压的相对扩展不确定度为4.4%(包含因子k=2)。The detonation pressure and detonation reaction zone are important for the detonation performance evaluation of explosives.In order to obtain the reaction zone parameters of several common high explosives,the detonation wave profiles in TNT,PETN,RDX,HMX,TATB and CL-20 based explosives were experimentally measured with photon Doppler velocimetry(PDV).The explosive samples were initiated by explosive plane-wave lenses or a powder gun,and the thickness of the samples was more than 10 mm to insure a stable detonation in the test area.A transparent LiF window covered by a 0.7-μm-thick aluminum reflective coating on the distal side was attached to the explosive sample,and the particle velocity histories of the interface between the explosive and window were measured with PDV.The Chapman-Jouguet(CJ)point was determined by the inflexion point in the corresponding profile or the separation point of the particle velocity histories for samples of different lengths.The CJ pressure was calculated using the impedance matching method.The pressure at the von Neumann(VN)spike was also obtained.The results show that for ideal explosives such as PETN,RDX,HMX and CL-20,the interface particle velocity profiles show a distinct end of the reaction zone,and the detonation reaction zones are narrow.The detonation reaction time is between 7 ns and 15 ns for those ideal explosives.For TNT and TATB based explosives,measurements show an indistinct end of the reaction zone because the reaction of solid carbon formation is slow,and the detonation reaction time is about(100±15)ns and(255±20)ns,respectively.The ratio of the measured spike pressure to CJ pressure of the explosives ranges from 1.22 to 1.46.The analysis indicates that the relative expanded uncertainty of the detonation pressure measured with PDV is 4.4%at k=2,and the uncertainty of the detonation reaction time is 2-4 ns for those ideal explosives or 10-20 ns for those unideal explosives.

关 键 词：爆压 反应区宽度 激光干涉测速技术 CL-20 爆炸测试技术 

分 类 号：O381[理学—流体力学] TJ55[理学—力学]