单组分甲基改性硅溶胶的制备与性能分析  

Preparation and Properties Analysis of One-Component Methyl-Modified Silica Sol

作　　者：郑文杰 刘峰 黎春阳[1] 李国军[1] ZHENG Wen-jie;LIU Feng;LI Chun-yang;LI Guo-jun(Materials Science Engineering School,Dalian Jiaotong University,Dalian 116028,China)

机构地区：[1]大连交通大学材料科学与工程学院,辽宁大连116028

出　　处：《材料保护》2022年第5期129-133,共5页Materials Protection

基　　金：国家重点研发计划(No.2020YFB2007800)资助。

摘　　要：硅溶胶的硅氧键由于刚度太大而易在成膜交联过程中形成微裂纹。为了弥补这一缺陷,以硅烷偶联剂与硅溶胶为原料,通过溶胶-凝胶法制备出改性硅溶胶溶液,并将其涂在铝板表面;研究了硅溶胶的pH值、 pH值调节剂种类、反应时间对改性硅溶胶产物及其涂层性能的影响,采用傅里叶红外光谱仪、热重分析仪和接触角测定仪等对涂层性能进行了表征。结果表明:改性后的硅溶胶性能稳定,其涂层表面光滑,铅笔硬度达到6 H,耐温500℃,接触角约为91°,热稳定性良好。As the silicon-oxygen bond of silica sol is too rigid, it is easy to form microcracks during the film-forming cross-linking process. To overcome this problem, modified silica sol solution was prepared by sol-gel method using silane coupling agent and silica sol as raw materials, and coated on the surface of aluminum plate. The effects of pH value of silica sol, pH regulator type and reaction time on the properties of the above-mentioned silica sol and coating were studied, and the properties of such coating were characterized through Fourier transform infrared(FT-IR) spectroscopy, thermogravimetry(TG) and contact angle analyzer. Results showed that the modified silica sol had stable properties and the coating had a smooth surface, a pencil hardness up to 6 H, a temperature resistance of 500 ℃, a contact angle of 91°, and a good thermal stability.

关 键 词：硅溶胶 溶胶-凝胶法 硅烷偶联剂 改性 涂层 疏水性 

分 类 号：TB43[一般工业技术]