硅光电倍增管自动增益校正系统设计  

Design of automatic gain correction system for silicon photomultiplier tube

作　　者：张琦 王传伟 李洪涛[2] Zhang Qi;Wang Chuanwei;Li Hongtao(Graduate School of China Academy of Engineering Physics,Beijing 100088,China;Key laboratory of Pulsed Power,Institute of Fluid Physics,CAEP,P.O.Box 919-108,Mianyang 621900,China)

机构地区：[1]中国工程物理研究院研究生院,北京100088 [2]中国工程物理研究院流体物理研究所,脉冲功率科学与技术重点实验室,四川绵阳621900

出　　处：《强激光与粒子束》2022年第7期155-160,共6页High Power Laser and Particle Beams

基　　金：国家自然科学基金项目(11905208)。

摘　　要：温度会使硅光电倍增管的增益产生较大的漂移,进而影响硅光电倍增管的增益精度。为了使硅光电倍增管增益不随温度发生较大变化,设计了硅光电倍增管的自动增益校正系统,包括基于单片机的高压电源设计与采集系统设计。高电压模块精确工作的温度范围为−10~60℃,电源噪声约为30 mV,满足硅光电倍增管性能测试的需求。采集系统经过扫频测试与激光照射测试,可以较好地通过60 MHz的交流信号,并将光信号转变为较明显的电信号。该系统可以向京邦公司的硅光电倍增管阵列JARY-TP3050-8X8C提供工作电压与采集电路。The gain of silicon photomultiplier tube will drift greatly due to temperature variation,which will affect the gain accuracy of silicon photomultiplier tube.To realize that silicon photomultiplier tube gain does not change greatly with temperature variation,an automatic gain correction system for silicon photomultiplier tube is designed,including the design of a high voltage power supply and an acquisition system based on single chip microcomputer.The high voltage module can accurately operate in the temperature range of−10℃to 60℃,and the power noise is about 30 mV,which can meet the requirements of silicon photomultiplier tube performance testing.Through frequency sweep test and laser irradiation test,the acquisition system can better pass the 60 MHz AC signal,and transform the optical signal into a more obvious electrical signal.The system provides a working voltage and acquisition circuit to Jingbon Compony’s silicon photomultiplier tube array JARY-TP3050-8X8C.

关 键 词：SIPM STM32 自动增益校正 LM2576-ADJ DS18B20 

分 类 号：TP272[自动化与计算机技术—检测技术与自动化装置]