煤气化粗合成气吸附除尘器压差信号分析  

Analysis of differential pressure signal of adsorption dust collector for coal gasification crude syngas

作　　者：曹均丰 柳伟 刘昶 郝文月 郭俊辉 廖杰峰 谢文杰 黄薇 Cao Junfeng;Liu Wei;Liu Chang;Hao Wenyue;Guo Junhui;Liao Jiefeng;Xie Wenjie;Huang Wei(SINOPEC Dalian Research Institute of Petroleum and Petrochemicals,Dalian,Liaoning 116045)

机构地区：[1]中国石油化工股份有限公司大连石油化工研究院,辽宁省大连市116045

出　　处：《炼油技术与工程》2022年第7期26-29,共4页Petroleum Refinery Engineering

摘　　要：在煤气化粗合成气除尘器内分级装填惰性保护剂,对煤气化粗合成气进行了552 d的除尘处理。在此期间,每天对除尘器入口与出口的压差信号进行测量,对压差信号进行了一维离散小波分析。通过分析对比,采用db5小波,在尺度为7、保留能量为99.78%时,分析效果较好。然后采用傅里叶拟合、指数拟合、高斯拟合、线性拟合和正弦拟合的方法对消噪处理后的压差信号进行拟合,拟合优度R_(2)分别为0.9949,0.9968,0.9974,0.9996,0.9989,拟合优度R_(2)均在0.99以上。Inert protective agent is filled in the dust collector of coal gasification crude syngas by stages, and the coal gasification crude syngas is dedusted for 552 d. During this period, the differential pressure signal at the inlet and outlet of the dust collector is measured every day, and the differential pressure signal is analyzed by one-dimensional discrete wavelet. Through analysis and comparison, when db5 wavelet is used, the scale is 7 and the reserved energy is 99.78%, the analysis effect is better. Then Fourier fitting, exponential fitting, Gaussian fitting, linear fitting and sinusoidal fitting are used to fit the denoised differential pressure signal. The goodness of fit R_(2) is 0.994 9, 0.996 8, 0.997 4, 0.999 6 and 0.998 9 respectively, and the goodness of fit R_(2) values are all above 0.99.

关 键 词：煤气化 粗合成气 吸附除尘器 压差信号 小波消噪 指数拟合 傅里叶拟合 

分 类 号：TQ545[化学工程—煤化学工程]