振动摩擦焊机机架三维建模与模态分析  

Frame Design and Modal Analysis of Vibration Friction Welding Equipment

作　　者：李鳌 刘剑雄[1] 曾家兴 万祥明 贾有东 刘建新 Li Ao;Liu Jianxiong;Zeng Jiaxing;Wan Xiangming;Jia Youdong;Liu Jianxin(Faculty of Mechanical and Electrical Engineering,Kunming University of Science and Technology,Kunming City,Yunnan Province 650504,China)

机构地区：[1]昆明理工大学机电工程学院,云南省昆明市650504

出　　处：《农业装备与车辆工程》2022年第7期147-149,160,共4页Agricultural Equipment & Vehicle Engineering

摘　　要：通过ANSYS仿真分析软件研究了振动摩擦焊接机机架在无阻尼状态下的固有频率和振型,讨论了共振可能带来的机构变形、失效等问题。研究结果表明:外部激振频率在220~260 Hz之间,高于振动摩擦焊机架6阶的最高固有频率65 Hz,因此不会发生共振,机架安全性不受影响,振动摩擦焊接机可以稳定安全地工作,机架设计合理。The natural frequency and mode shape of the frame under undamped condition were studied by ANSYS simulation software,and the possible deformation and failure problems were further discussed.The results show that the external vibration frequency is 220~260 Hz,higher than the highest natural frequency of the vibration friction welding machine frame of the 6th order,65 Hz,therefore,resonance phenomenon will not occur,and there is no excessive influence on the safety of the vibration friction welding machine.The vibration friction welding machine can work stably and safely,and the frame design is reasonable.

关 键 词：振动摩擦焊 机架 模态分析 共振 

分 类 号：TG439.8[金属学及工艺—焊接]