检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:熊远亮 朱玉 李保亮[1,3] 陈春 张亚梅[1] XIONG Yuanliang;ZHU Yu;LI Baoliang;CHEN Chun;ZHANG Yamei(Jiangsu Key Laboratory of Construction Materials,School of Materials Science and Engineering,Southeast University,Nanjing 211189,China;School of Civil Engineering,Yantai University,Yantai 264005,China;Faculty of Architecture and Civil Engineering,Huaiyin Institute of Technology,Huai’an 223001,China)
机构地区:[1]东南大学材料科学与工程学院,江苏省土木工程材料重点实验室,南京211189 [2]烟台大学土木工程学院,烟台264005 [3]淮阴工学院建筑工程学院,淮安223001
出 处:《硅酸盐通报》2022年第8期2792-2799,共8页Bulletin of the Chinese Ceramic Society
基 金:南京市科技委员会项目(201727002)。
摘 要:本文采用镍铁渣机制砂(简称镍铁渣砂)制备泡沫混凝土,研究镍铁渣砂对泡沫混凝土抗压强度、变形及收缩开裂的影响,并采用SEM、X-CT研究泡沫混凝土微观结构。结果表明,镍铁渣砂掺量为5%(质量分数,下同)时泡沫混凝土的抗压强度最高,而镍铁渣砂掺量超过10%时会引入界面缺陷,降低混凝土的强度。镍铁渣砂能够约束基体的变形,减少水泥用量,降低泡沫混凝土的收缩,提高其抗裂性能。当镍铁渣砂掺量由0%增加到20%时,泡沫混凝土的抗裂等级由V级提高到II级。镍铁渣砂具有作为泡沫混凝土生产原料的潜力。In this study,ferronickel slag artificial sand(ferronickel slag sand)was used to produce foamed concrete.Effect of ferronickel slag sand on the compressive strength,deformation and shrinkage cracking of foamed concrete was investigated.Meanwhile,SEM and X-CT were used to investigate the microstructure.Experimental results reveal that the foamed concrete with 5%(mass fraction,the same below)ferronickel slag sand possesses the highest compressive strength.However,too many interfacial defects can be introduced with the addition of ferronickel slag sand above 10%,thus decreasing the compressive strength of the foamed concrete.The ferronickel slag sand can restrict the deformation of the matrix,decrease the usage of cement,mitigate the drying shrinkage of the foamed concrete,and enhance its crack resistance.When the content of ferronickel slag sand increased from 0%to 20%,the crack resistance grade of the foam concrete increases from V to II.Overall,ferronickel slag sand has potential to be used as a raw material in producing foamed concrete.
关 键 词:泡沫混凝土 镍铁渣机制砂 孔结构 抗压强度 收缩 开裂
分 类 号:TQ178[化学工程—硅酸盐工业]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222