检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:聂伟晓 温垚珂[1] 董方栋 覃彬 罗小豪 童梁成 NIE Weixiao;WEN Yaoke;DONG Fangdong;QIN Bin;LUO Xiaohao;TONG Liangcheng(School of Mechanical Engineering,Nanjing University of Science and Technology,Nanjing 210094,Jiangsu,China;Science and Technology on Transient Impact Laboratory,No.208 Research Institute of China Ordnance Industries,Beijing 102202,China;Department of Orthopedics,Eastern Air Force Hospital of PLA,Nanjing 210002,Jiangsu,China)
机构地区:[1]南京理工大学机械工程学院,江苏南京210094 [2]中国兵器工业第208研究所瞬态冲击技术重点实验室,北京102202 [3]解放军东部战区空军医院骨科,江苏南京210002
出 处:《兵工学报》2022年第9期2075-2085,共11页Acta Armamentarii
基 金:国家自然科学基金项目(11872215);国防基础科研项目(JCKYS201909C001);军委科技委基础加强计划技术领域基金项目(2020-JCJQ-JJ-403、2019-JCJQ-JJ-373)。
摘 要:为研究低速破片对于佩戴防弹头盔的人体头部靶标的杀伤效应,基于枪弹侵彻防弹头盔的3D-DIC试验和和头部撞击试验验证复合材料头盔仿真模型和头部有限元模型的准确性,构建6 mm钢球破片侵彻戴防弹头盔人体头部靶标的数值模型,开展破片从正面、侧面和顶部3个方向的侵彻效应数值模拟。研究结果表明:当破片以600 m/s的入靶速度侵彻时,正面、侧面和顶部侵彻弹着点处的瞬态鼓包高度分别为10.2 mm、11.3 mm和11.5 mm,表明有头部支撑头盔的情况下破片侵彻造成的背面鼓包高度接近;正面侵彻过程弹着点底部颅骨应力最大,侧面侵彻颅骨弹着点底部应力最小,破片侵彻造成的颅骨应力均不会超过损伤阈值,表明低速破片侵彻不会造成颅骨损伤;正面、侧面和顶部侵彻造成的颅内压峰值分别为495 kPa、110 kPa和327 kPa,表明在破片侵彻中侧面的防护效果最好,正面和顶部的颅内压峰值可以造成脑损伤。In order to study the killing effect of low-velocity fragments on the human head target wearing a bulletproof helmet,this paper firstly verified the accuracy of the simulation model of the composite helmet and the finite element head model based on the 3D-DIC test of the bullet penetrating the bulletproof helmet and the head impact test.Then,the numerical model of the 6 mm steel ball fragment penetrating the human head target wearing a bulletproof helmet was constructed,and the numerical simulation of the penetration effect of the fragment from the front,side and top directions were carried out.The research results show that when the fragment penetrates at a target speed of 600 m/s,the transient bulge heights at the impact points of the frontal,side and top penetration bullets are 10.2 mm,11.3 mm and 11.5 mm,respectively,indicating that there is head support.In the case of a helmet,the height of the back bulge caused by fragment penetration is similar;the skull stress at the bottom of the impact point during frontal penetration is the largest,and the stress at the bottom of the impact point of side penetration is the smallest.The skull stress caused by fragment penetration will not exceed the damage threshold,which indicates that low speed Fragment penetration did not cause skull damage;peak intracranial pressures were 495 kPa,110 kPa,and 327 kPa due to frontal,lateral,and top penetration,respectively,indicating the best protection in the mid-lateral,frontal and top penetrations Peak intracranial pressure can cause brain damage.
分 类 号:TJ012.4[兵器科学与技术—兵器发射理论与技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.220.121.27