气力式蔬菜精量排种器优化设计与试验  

Opti mized Design and Experiment of Single-plate Multi-row Independent Airway Vegetable Precision Seed Meter

作　　者：李晓冉 张银平[1] 刁培松[1] 谢志刚 崔志超 Li Xiaoran;Zhang Yinping;Diao Peisong;Xie Zhigang;Cui Zhichao(College of Agricultural Engineering and Food Science,Shandong University of Technology,Zibo 255049,China;Shandong Liaocheng Academy of Agricultural Sciences,Liaocheng 252000,China;Nanjing Institute of Agricultural Mechanization,Ministry of Agriculture,Nanjing 210014,China)

机构地区：[1]山东理工大学农业工程与食品科学学院,山东淄博255049 [2]山东省聊城市农业科学院,山东聊城252000 [3]农业农村部南京农业机械化研究所,南京210014

出　　处：《农机化研究》2023年第5期88-92,共5页Journal of Agricultural Mechanization Research

基　　金：山东省农业重大应用技术创新项目(SD2019NJ005);山东省农机装备创新研发计划项目(2018YF005-04);江苏省农业科技自主创新项目(CX[18]3050)。

摘　　要：针对现有多行气吸式排种器因共用气室造成风压要求高、损失大的问题,设计了一种单盘多行独立气道式精量排种器。通过在紧贴排种盘吸气侧设计带有凹槽的气道盘,将气室分成相互独立的3条气道,分别对应排种盘上的3条排种行,从而降低排种过程所需的风压值,减少风压损失。对关键部件进行了仿真分析和对比试验,结果表明:吸种合格率达95%以上时,所需负压值比传统大气室排种器降低了1kPa。Aiming at the problems of high wind pressure requirements and large losses caused by the common air chamber of the existing multi-row air suction seed metering device,a single disc multi-row independent airway precise metering device is designed.By designing an airway plate with grooves close to the suction side of the seeding plate,the air chamber is divided into three independent airways,which correspond to the three seeding rows on the seeding plate,thereby reducing seeding.The wind pressure value required by the process,reducing the wind pressure loss.The simulation analysis and comparison test show that the required negative pressure value is 1kPa lower than that of the traditional air chamber seed meter when the qualified rate of seed suction reaches more than 95%.

关 键 词：排种器 精量 独立气道 仿真分析 蔬菜 

分 类 号：S223.26[农业科学—农业机械化工程] S220.3[农业科学—农业工程]