检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:扶鑫 樊洁[1,2] 马婉霞 左方涛 朱朝梁 邓小川[1,2] FU Xin;FAN Jie;MA Wan-xia;ZUO Fang-tao;ZHU Chao-liang;DENG Xiao-chuan(Key Laboratory of Comprehensive and Highly Efficient Utilization of Salt Lake Resources,Qinghai Institute of Salt Lakes,Chinese Academy of Sciences,Xining,810008,China;Qinghai Engineering and Technology Research Center of Comprehensive Utilization of Salt Lake Resources,Xining,810008,China;University of Chinese Academy of Sciences,Beijing,100049,China)
机构地区:[1]中国科学院青海盐湖研究所,中国科学院盐湖资源综合高效利用重点实验室,青海西宁810008 [2]青海省盐湖资源开发工程技术研究中心,青海西宁810008 [3]中国科学院大学,北京100049
出 处:《盐湖研究》2023年第1期67-76,共10页Journal of Salt Lake Research
基 金:中国科学院绿色过程制造创新研究院自主部署项目(IAGM-2019A04)。
摘 要:从高镁锂比盐湖提锂生产尾液中回收锂,可实现锂资源高效回收利用,对企业经济效益的提高具有重要意义。以东台吉乃尔盐湖提锂尾液为原料,系统性研究了铝系层状锂吸附剂JW-LAHS对提锂尾液中锂的静态、动态吸附和解吸过程。结果表明,吸附剂的静态吸附容量为7.3 mg/g,镁锂分离因子为27.98;最佳动态吸附条件为床层高度24.8 cm,进料流速3.5 mL/min,此时穿透时间为22.0 min,Li+吸附率大于95%,饱和时间为210 min,饱和吸附容量达到5.5 mg/g,表明锂吸附剂适合从高镁锂比提锂尾液中回收锂。BDST模型能够准确预测床层穿透时间,误差小于8.61%。使用去离子水进行解吸,增大解吸流速能够加速Li+脱出,但对Mg^(2+)的解吸无明显影响。解吸流速为4.6 mL/min,解吸360 min时,Li+解吸率为83.25%,总解吸液的镁锂比值为0.7,仅为提锂尾液(80)的0.88%。循环20次后吸附容量仍能保持原来的82%以上,表明锂吸附剂循环稳定性良好。Recycling the lithium in the tail solution of lithium extraction from salt lake to realize efficient recovery and utilization of lithium resources is significant to increase the economic benefits of the enterprises.In this paper,the batch and dynamic experiments were carried out to investigate the adsorption and desorption performance of aluminum salt layered lithium-adsorbent JW-LAHS in the lithium extraction tail solution from East Taijinar Salt Lake.The static adsorption capacity of adsorbent JW-LAHS is 7.3 mg/g,and the separation factor of magnesium and lithium is 27.98.When fixed bed height at 24.8 cm and feed flow rate at 3.5 mL/min,breakthrough time is 22.0 min,adsorption saturation time is 210.0 min,adsorption saturation capacity is 5.5 mg/g,and adsorption rate of Li+before bed breakthrough is more than 95%.This indicates that the adsorbent JW-LAHS is suitable for lithium recovery from the lithium extraction tail solution with a high Mg/Li ratio.The BDST model can accurately predict the breakthrough time with an error less than 8.61%.Deionized water was used for desorption.It is found that increasing flow rate can accelerate the Li+desorption process,while it has no remarkable influence on the Mg^(2+)desorption process.When the feed flow rate is at 4.6 mL/min for 360 min,the desorption rate of Li+is up to 83.25%.The Mg/Li mass ratio of the desorption solution is only 0.88%of the lithium extraction tail solution(Mg/Li mass ratio 80).The adsorption capacity of JW-LAHS remains more than 82%after 20 cycles,indicating good cycling stability of the adsorbent.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.145