检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:陈爽 白根铭 肖畅 曲宏略 汪林[1] 刘哲言 CHEN Shuang;BAI Genming;XIAO Chang;QU Honglue;WANG Lin;LIU Zheyan;无(Yunnan Infrastructure Investment Co.,Ltd.,Kunming Yunnan 650500,China;China Railway Society,Beijing 100844,China;School of Geoscience and Technology,Southwest Petroleum University,Chengdu Sichuan 610500,China;Nuobikan-Southwest Jiaotong University Industry-University-Research Joint Laboratory,Chengdu Sichuan 610031,China)
机构地区:[1]云南建设基础设施投资股份有限公司,云南昆明650500 [2]中国铁道学会,北京100844 [3]西南石油大学地球科学与技术学院,四川成都610500 [4]诺比侃-西南交大产学研联合实验室,四川成都610031
出 处:《中国安全科学学报》2023年第2期146-151,共6页China Safety Science Journal
基 金:国家自然科学基金资助(51809221);深部岩土力学与地下工程国家重点实验室开放基金资助(SKLGDUEK1910);蔓耗至金平高速公路项目(JTSZ-MJGS-2019-042)。
摘 要:为减少地下工程区断层等地质构造对局部应力场的影响,以云南省红河州某高速公路隧道工程为例,分析隧道选址区域初始地应力场。首先,建立隧道选址区域三维地质模型,使用空芯包体法采集10处测点的初始地应力数据;然后,根据实测地应力数据,通过多元线性回归反演分析方法反演,得到隧道选址区岩体初始地应力场,同时,在该方法的基础上考虑区域内断层和破碎带的影响,总结断层对地应力分布状态的影响;最后,根据现场勘察所得地质构造条件(主要为断层),对断层带施加挤压力和压扭力模拟断层错动,从而进行局部地应力调整,得到符合实际的地应力场。结果表明:研究区域水平垂直隧道轴线方向的应力最大,表现为σy>σz>σx;应力值在断层内部减小,断层带边缘增大。在高地应力硬岩隧道工程中,应力集中的断层边缘存在岩爆发生概率增大的可能性,应加强防治,以保障施工过程安全。In order to reduce the influence of geological structures such as faults on the local stress field in the underground engineering area,an expressway tunnel project in Honghe Prefecture,Yunnan Province was taken as an example to analyze the initial ground stress field in the tunnel site selection area.Firstly,a three-dimensional geological model of the tunnel site selection area was established,and the initial stress data of 10 measuring points were collected by the hollow inclusion method.Then,according to the measured in-situ stress data,the initial in-situ stress field of rock mass in the tunnel site was obtained by multiple linear regression inversion analysis.At the same time,the influence of faults and fracture zones in the area was considered on the basis of this method,and the influence of faults on the distribution of in-situ stress was summarized.Finally,according to the geological structure conditions(mainly faults)obtained from field investigation,the fault dislocation was simulated by applying compressive and torsion forces to the fault zone,so as to adjust the local in-situ stress and obtain the actual in-situ stress field.The results show that the stress in the horizontal and vertical direction of the tunnel axis in the study area is the largest,which isσy>σz>σx.The stress value decreases inside the fault and increases at the edge of the fault zone.In the high ground stress hard rock tunnel project,the edge of the fault with stress concentration has the possibility of increasing the probability of rockburst,andprevention and control should be strengthened to ensure the safety of the construction process.
关 键 词:断层 高地应力 隧道 初始地应力场 地应力反演 多元线性回归 空芯包体法
分 类 号:X935[环境科学与工程—安全科学] U451[建筑科学—桥梁与隧道工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.200