Experimental study on the wear evolution of different PVD coated tools under milling operations of LDX2101 duplex stainless steel  

作　　者：Vitor F.C.Sousa Francisco J.G.Silva Ricardo Alexandre Jose S.Fecheira Gustavo Pinto Andresa Baptista 

机构地区：[1]ISEP-School of Engineering,Polytechnic of Porto,Rua Dr.António Bernardino de Almeida,431,4200–072,Porto,Portugal [2]INEGI-Driving Science and Innovation,Rua Dr.Roberto Frias,400,4200–465,Porto,Portugal [3]TEandM-Technology,Engineering and Materials,S.A.,Parque Industrial do Taveiro,Lotes 41-42,3045–504,Taveiro,Portugal

出　　处：《Advances in Manufacturing》2023年第1期158-179,共22页先进制造进展（英文版）

基　　金：The present work was done and funded under the scope of the project ON-SURF(ANI|P2020|POCI-01-0247-FEDER-024521,co-funded by Portugal 2020 and FEDER,through COMPETE 2020-Operational Programme for Competitiveness and Internationalisation.

摘　　要：Duplex stainless steels are being used on applications that require,especially,high corrosion resistance and overall good mechanical properties,such as the naval and oil-gas exploration industry.The components employed in these industries are usually obtained by machining,however,these alloys have low machinability when compared to conventional stainless steels.In this work,a study of the wear developed when milling duplex stainless-steel,LDX 2101,is going to be presented and evaluated,employing four types of milling tools with different geometries and coatings,while studying the influence of feed rate and cutting length in the wear of these tools.Tools used have been provided with two and four flutes,as well as three different coatings,namely:TiAlN,TiAlSiN and AlCrN.The cutting behavior of these tools was analyzed;data relative to the cutting forces developed during the process were obtained;and roughness measurements of the machined surfaces were executed.The tools were then submitted to scanning electron microscope(SEM)analysis,enabling the identification of the wear mechanisms that tools were subjected to when machining this material,furthermore,the early stages of these mechanisms were also identified.All this work was done with the goal of relating the machining parameters and cutting force values obtained,identifying,and discussing the wear patterns that were observed in the coating and tools after the milling tests,providing further information on the machining of these alloys.

关 键 词：Duplex stainless-steel MILLING Tool coatings Surface roughness Wear mechanisms 

分 类 号：TG142.71[一般工业技术—材料科学与工程]