检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:丁洋[1] 卢强[1] 李进[1] 郭志昀[1] 王占江[1] DING Yang;LU Qiang;LI Jin;GUO Zhiyun;WANG Zhanjiang(Northwest Institute of Nuclear Technology,Xi’an 710024,Shaanxi,China)
出 处:《爆炸与冲击》2023年第5期123-136,共14页Explosion and Shock Waves
基 金:国家自然科学基金(12072290)。
摘 要:余弦分布载荷的化爆加载技术是高空核爆软X射线辐照下空间结构动态响应考核的主要手段。为适应新型空间飞行器结构考核的复杂构型、高同步性和低比冲量载荷设计要求,提出了一种用十字形超细药条离散群同步起爆实现超低比冲量加载的方法。实验结果验证表明:(1)所制作的十字形超细药条,最小截面尺寸为0.33 mm×0.5 mm,传爆性能稳定,并可通过直径0.5 mm的柔爆索直接起爆;(2)与相同布药密度的条状布药方式相比,布药空间均匀度提高了76.7%;(3)所采用的21点柔爆索同步起爆网络,起爆率达100%,起爆不同步性小于1μs。进一步建立了离散片炸药加载数值计算模型,分析了离散片炸药群同步起爆加载的比冲量空间分布和匀化规律,将匀化过程分为扩散段、叠加段和均匀段3个阶段;对比了方形、十字形、短条形3种形状药片阵列的比冲量演化过程,发现十字形药片所需匀化距离最短、均匀度最高,仅需约0.8倍布药间距即可使比冲量均匀度偏差降至10%以下。The loading technology of cosine distributed load by chemical explosion is the main method for evaluating the dynamic response of space structures under the irradiation of high-altitude nuclear explosions with soft X-rays.A loading method of discretely-distributed sheet explosives synchronously detonated by a mild detonating fuse(MDF)network was proposed to meet the design requirements of complex configuration,high synchronicity and low specific impulse load in the structural assessment of new space vehicles.In terms of experimental study,the cross-shaped sheet explosive made by stacking explosive strips with a cross-sectional size of 0.33 mm×0.5 mm can be directly detonated by a mild detonating fuse with the diameter of 0.5 mm.Compared with strip distribution,the space uniformity of cross distribution is improved by 76.7%.A highspeed camera was used to record the shock wave luminescence during the detonation process.The results show that the detonation ratio of the 21-point MDF detonation network reaches 100%,and the detonation asynchrony is less than 1μs.In terms of numerical simulation,a numerical model for the explosion of sheet explosives was established based on the multimaterial arbitrary Lagrangian-Eulerian(ALE)algorithm.The numerical model has strong grid sensitivity,and the results by it tend to converge when the mesh size reaches 0.5 mm,with the deviation from the measured specific impulse results within 5%.Based on the numerically-simulated results,the following conclusions can be drawn.(1)Under the periodic discrete distribution condition,the peak specific impulse is determined by the surface density of the explosive,and the evolution process of the peak specific impulse is determined by the spacing.(2)The homogenization process of specific impulse can be divided into three stages:diffusion stage,superposition stage and uniform stage.The specific impulse is homogenized through free diffusion of shock wave in the diffusion stage,and through shock wave superposition and collision in the superposition
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.33