检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:胡帅帅 许智鹏 雷子萱 陈双 刘育红[2] 强军锋[1] HU Shuaishuai;XU Zhipeng;LEI Zixuan;CHEN Shuang;LIU Yuhong;QIANG Junfeng(College of Material Science and Engineering,Xi an University of Science and Technology,Xi an 710000,China;School of Chemical Engineering and Technology,Xi an Jiaotong University,Xi an 710000,China)
机构地区:[1]西安科技大学材料科学与工程学院,西安710000 [2]西安交通大学化学工程与技术学院,西安710000
出 处:《材料导报》2023年第11期226-233,共8页Materials Reports
摘 要:采用二乙二醇二甲基丙烯酸酯(DEGDMA)和三乙二醇二甲基丙烯酸酯(3EGDMA),分别与脂环族环氧树脂(TTA-21)共混,构建了TTA-21/DEGDMA和TTA-21/3EGDMA阳离子/自由基混杂光固化体系,探究了上述体系的组成对固化薄膜力学性能的影响。在此基础上,全面讨论了甲基丙烯酸缩水甘油醚(GMA)的添加量对TTA-21/3EGDMA拉伸强度、断裂韧性、透光率以及热机械性能和微观形貌的影响。结果表明,GMA添加量为20%时,组分比为2∶1的TTA-21/3EGDMA薄膜拉伸强度为65.74 MPa,断裂伸长率为4.80%;GMA添加量为40%时,K IC可达2.74 MPa·m 1/2,提高了17.52%。不同GMA添加量的TTA-21/3EGDMA薄膜透光率均可达89.95%以上。随着GMA添加量的增多,固化物交联密度增加,GMA添加量大于30%后,出现了微相分离,增加了薄膜的柔韧性。In this paper,diethylene glycol dimethacrylate(DEGDMA)and triethylene glycol dimethacrylate(3EGDMA)were blended with cycloaliphatic epoxy resin(TTA-21)to construct TTA-21/DEGDMA and the cationic/radical hybrid light curing system of TTA-21/3EGDMA,the influence of the composition of the above system on the mechanical properties of the cured film was explored,and the composition TTA-21/3EGDMA with better performance was selected.On this basis,the effect of the addition of glycidyl methacrylate(GMA)on the tensile strength,fracture toughness,light transmittance,thermomechanical properties and micro morphology of TTA-21/3EGDMA was comprehensively discussed.The results show that when GMA is added at 20%,the tensile strength of TTA-21/3EGDMA film with a composition ratio of 2∶1 is 65.74 MPa,and the elongation at break is 4.80%;when GMA is added at 40%,KIC can reach 2.74 MPa·m 1/2,an increase of 17.52%.The light transmittance of TTA-21/3EGDMA film with different GMA addition amount can reach more than 89.95%.As the amount of GMA added increases,the crosslink density of the cured product increases.After the amount of GMA added is greater than 30%,micro-phase separation occurs,which increases the flexibility of the film.
关 键 词:紫外光聚合 环氧树脂 薄膜封装 拉伸强度 OLED
分 类 号:TQ323.5[化学工程—合成树脂塑料工业]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.217.119.115