检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:郭增伟 张亚丽 杨一帆 周水兴[1] GUO Zengwei;ZHANG Yali;YANG Yifan;ZHOU Shuixing(School of Civil Engineering,Chongqing Jiaotong University,Chongqing 400074,China)
出 处:《重庆交通大学学报(自然科学版)》2023年第5期16-24,共9页Journal of Chongqing Jiaotong University(Natural Science)
基 金:国家自然科学基金项目(51878106);重庆市自然科学基金面上项目(cstc2019jcyj-msxmX0818);重庆市教委科学技术研究项目(KJZD-K202100704);重庆市研究生联合培养基地建设项目(JDLHPYJD2020023)。
摘 要:为探究日照辐射作用下钢管混凝土拱肋的梯度温度效应,依托四川省犍为岷江特大桥工程实时采集钢管表面温度,建立了考虑钢管-混凝土界面接触状态的热力耦合模型,进行了钢管混凝土拱肋梯度温度及应力分析,揭示了四川服役的钢管混凝土拱桥在日照影响下其截面梯度温度沿直径D方向的时变规律,及钢管-混凝土界面接触应力在空间方向上的分布模式,并给出了径向梯度温度计算公式以及特征参数取值。研究表明:日照作用下钢管混凝土截面径向温度分布极不均匀,距钢管顶D/8深度范围内温度梯度结果较JTG D60—2015中推荐值高5℃左右,较TB 10092—2017高8℃左右,此外,在D/2处仅为TB 10092—2017推荐值的50%;钢管-混凝土界面应力在1 d内呈现“拉-压”交变现象,在14:00、15:00拉应力峰值高达0.8 MPa,在设计与施工过程中采取适当措施以实现管内混凝土产生超过0.8 MPa的膨胀压应力,避免管内混凝土出现脱空现象。In order to explore the gradient temperature effect of concrete-filled steel tubular arch rib under sunlight radiation,a thermo-mechanical coupling model considering the interface contact state between steel tube and concrete was established,which was based on the real-time collection of the surface temperature of the steel tube in the Minjiang River Bridge project in Qianwei,Sichuan Province.The gradient temperature and stress analysis of concrete-filled steel tubular arch ribs were carried out and the time-varying laws of the cross-sectional gradient temperature along the diameter D direction and the spatial distribution mode of steel tube-concrete interface contact stress of the concrete-filled steel tubular arch bridge in service in Sichuan under the influence of sunlight were revealed.Moreover,the radial gradient temperature calculation formula and characteristic parameter values were given.The research shows that the radial temperature distribution of CFST section is seriously inhomogeneous under the influence of sunlight.The temperature gradient within the depth range of D/8 from the steel pipe top is about 5℃higher than the recommended value in JTG D60—2015 and about 8℃higher than that in TB 10092—2017.In addition,at D/2,it is only 50%of the recommended value in TB 10092-2017.The interface stress between steel pipe and concrete exhibits an alternating phenomenon of“tension-compression”within one day,with peak tensile stress reaching 0.8 MPa at 14:00 and 15:00.Therefore,the appropriate measures should be taken in the process of design and construction to make an expansion compressive stress of the concrete inside the tube exceed 0.8 MPa,so as to avoid the bond void phenomenon of the concrete inside the tube.
关 键 词:桥梁工程 钢管混凝土 日照温度场 实测试验 有限元模拟 梯度温度 接触应力
分 类 号:U441.5[建筑科学—桥梁与隧道工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.38