检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:郑彦龙 马中骏 李建春 赵晓豹[2] ZHENG Yanlong;MA Zhongjun;LI Jianchun;ZHAO Xiaobao(School of Civil Engineering,Southeast University,Nanjing 211189,Jiangsu,China;School of Earth Sciences and Engineering,Nanjing University,Nanjing 210093,Jiangsu,China)
机构地区:[1]东南大学土木工程学院,江苏南京211189 [2]南京大学地球科学与工程学院,江苏南京210093
出 处:《隧道建设(中英文)》2023年第8期1338-1347,共10页Tunnel Construction
基 金:国家自然科学基金(52104121,41831281);江苏省双创团队项目(JSSCTD202140);江苏省双创博士项目(201930618);中央高校基本科研业务费项目(2242022k30054)。
摘 要:为研究开放式微波作用下节理岩体的破裂特征,并评估微波辅助悬臂掘进机的破岩效率,开展微波致裂模拟节理岩体试验。首先,利用9块尺寸为0.5 m×0.5 m×0.3 m(长×宽×厚)的闪长岩岩样垒成1.5 m×1.5 m×0.3 m(长×宽×厚)的人造节理岩体,以模拟节理间距为0.5 m的岩石开挖面;然后,利用6 kW的工业微波系统及缩径介质填充天线对该节理岩体进行微波照射加热致裂试验,研究不同微波照射点间距(15 cm和20 cm)下岩体的破裂特征,分析节理与照射点间距对微波致裂的影响,测量微波处理后岩体的等效岩石质量指标(RQD)和磨蚀性指数(CAI);最后,基于Bilgin经验模型评估微波照射前后刀盘功率为200 kW的悬臂掘进机的破岩效率和刀具磨损变化。结果表明:1)2种照射点间距下,岩体的等效RQD从100降低到62和50,微波预处理可使悬臂掘进机在该闪长岩岩体中的破岩效率提高170%~280%;2)照射点间距为20 cm时,CAI从4.0减少到3.4,可使刀具损耗降低11%。In order to investigate the fracturing characteristics of jointed rock mass subjected to open-ended microwave and estimate the efficiency of microwave-assisted rock breakage by roadheader,tests are conducted on an artificial rock mass under open-ended microwave.The artificial rock mass(1.5 m×1.5 m×0.3 m)is erected by nine diorite blocks(0.5 m×0.5 m×0.3 m)to simulate a working face with a 0.5 m joint spacing.The rock mass is treated point by point at a spacing of 15 cm and 20 cm,respectively,using a 6 kW microwave source and an open-ended antenna.The influences of radiation spacing and the distance from radiation to joint on the fracturing of the artificial rock mass are analyzed.The equivalent rock quality designation(RQD)of the microwave treated rock mass is then calculated and the improvement in the rock breakage efficiency of a 200 kW roadheader is estimated based on the Bilgin empirical model.The Crechar abrasivity indexes(CAI)of diorite with and without microwave treatment are measured.The results show that the equivalent RQD is reduced from 100 to 62 and 50 at an radiation spacing of 15 cm and 20 cm,respectively,and the CAI is reduced from 4.0 to 3.4 at the radiation spacing of 20 cm.Microwave treatment can significantly enhance the rock breakage efficiency of the roadheader by 170%~280%,and reduce the tool wear by 11%.
分 类 号:U45[建筑科学—桥梁与隧道工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.7