检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:申利梅[1,2] 胡博兴 谢雨霏 曾伟豪 张晓屿 SHEN Limei;HU Boxing;XIE Yufei;ZENG Weihao;ZHANG Xiaoyu(School of Energy and Power Engineering,Huazhong University of Science and Technology,Wuhan 430074,Hubei,China;Shenzhen Huazhong University of Science and Technology Research Institute,Shenzhen 518057,Guangdong,China;Beijing Micro Enthalpy Technology Co.,Ltd.,Beijing 100084,China)
机构地区:[1]华中科技大学能源与动力工程学院,湖北武汉430074 [2]深圳华中科技大学研究院,广东深圳518057 [3]北京微焓科技有限公司,北京100084
出 处:《化工学报》2023年第S01期198-205,共8页CIESC Journal
基 金:国家自然科学基金项目(52176007);深圳市科技计划基础研究重点项目(JCYJ20210324115611030)。
摘 要:随着电子器件的集成度逐渐提高,超薄平板热管作为一种适用于受限空间的高效散热器受到关注。本文对厚度为0.27mm的超薄平板热管进行传热性能的测试,以传热温差、传热量、热阻、等效传热系数作为指标,系统性地研究了加热功率、冷却方式及重力影响下的传热特性。研究发现,重力对超薄平板热管传热性能有轻微影响,竖直状态下的最大散热量较水平状态提高5%~10%,水平较竖直-逆重力状态提高2%~10%。冷却方式对其传热性能影响较大。在较低功率时,相比于自然冷却,强制冷却能使电子元器件在较低温度工作,但造成热管冷热端温差及热阻都比自然冷却条件下大,在超过一定功率(1.2W左右)后,温差及热阻急剧增大,等效传热系数减小,传热效果不佳。With the gradual improvement of the integration of electronic devices,ultra-thin flat heat pipe has attracted more and more attention as an efficient radiator suitable for confined space.In this paper,the heat transfer performance of ultra-thin flat heat pipe with thickness of 0.27 mm is tested.Taking the heat transfer temperature difference,heat transfer and thermal resistance as indicators,the heat transfer characteristics under the influence of heating power,cooling mode and gravity are systematically studied.It is found that gravity has a slight effect on the heat transfer performance of ultra-thin flat heat pipe.The maximum heat dissipation in vertical state is 5%—10%higher than that in horizontal state,and 2%—10%higher than that in vertical anti-gravity state.The cooling mode has a great influence on its heat transfer performance.At lower power,compared with natural cooling,forced cooling can make electronic components work at lower temperature,but the temperature difference and thermal resistance at the cold and hot ends of the heat pipe are greater than those under natural cooling.After exceeding a certain power(about 1.2 W),the temperature difference and thermal resistance increase sharply and the heat transfer effect is poor.
分 类 号:TK172.4[动力工程及工程热物理—热能工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.227.107.69