检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:孙志刚 郑永峰 唐书峰 张珊珊[2] SUN Zhigang;ZHENG Yongfeng;TANG Shufeng;ZHANG Shanshan(Yanzhou Shandong Construction Group Corporation,Jining 272100,China;Key Laboratory of Building Structural Retrofitting and Underground Space Engineering(Shandong Jianzhu University)Ministry of Education,Jinan 250101,China)
机构地区:[1]山东兖州建设总公司,山东济宁272100 [2]建筑结构加固改造与地下空间工程教育部重点实验室(山东建筑大学),济南250101
出 处:《工业建筑》2023年第8期52-57,共6页Industrial Construction
基 金:国家重点研发计划(2016YFC0701703);山东省住房城乡建设科技计划项目(2019-K9-7)。
摘 要:为验证预埋波纹管成孔钢筋约束浆锚搭接连接的可靠性,设计制作了60组、共180个接头试件并进行了单向拉伸试验,试件参数包括纵筋直径、混凝土强度、螺旋箍筋直径和螺距。结果表明:所有试件的抗拉强度与钢筋屈服强度标准值的比值均大于1.5,与钢筋抗拉强度标准值的比值大于1.1。对于直径10 mm和12 mm的接头试件,螺旋箍筋构造对接头抗拉强度的影响不明显。对于直径14 mm的试件,螺旋箍筋体积配箍率越大,箍筋螺距越小,混凝土损伤越小。在配箍率相差不大的情况下建议选择较小的箍筋直径和螺距。当螺旋箍筋配置为d4@50,纵筋公称直径≤14 mm时,搭接长度可取钢筋基本锚固长度。60 sets of 180 specimens were designed and manufactured to verify the reliability of the splice in which the rebars lapped in spiral stirrups confined grout-gilled corrugated pipes.The specimen parameters include longitudinal reinforcement diameter,concrete strength,and spiral rebar diameter and screw pitch.The monotonic tension loading test results indicated that the ultimate tensile strength of specimens all exceeded the 150 percent of the specified yielding strength and 110 percent of specified tensile strength of the lapped rebars.For the splice specimens with lapped rebar diameters of 10 mm and 12 mm,the effect of the spiral stirrups on the tensile strength of the splice specimens was not obvious.For the specimens with a rebar diameter of 14 mm,larger volume ratio and smaller screw pitch of the spiral stirrups could result in less damage of the concrete block under tension load.For a similar reinforcement ratio,it was recommended to use a smaller rebar diameter and screw pitch.When the spiral configuration was d4@50 and the nominal diameter of the longitudinal reinforcement was not more than 14 mm,the lap length could be taken as the basic anchorage length of rebar.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.12.163.164