检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:刘松涛 党小梅 贾文瑶 曹悦 张玉玲 陈传敏 LIU Songtao;DANG Xiaomei;JIA Wenyao;CAO Yue;ZHANG Yuling;CHEN Chuanmin(School of the Environmental Science and Engineering,North China Electric Power University(Baoding),Baoding 071003,China)
机构地区:[1]华北电力大学(保定)环境科学与工程系,河北保定071003
出 处:《工业水处理》2023年第10期71-78,共8页Industrial Water Treatment
基 金:国家自然科学基金项目(52170074)。
摘 要:为探究高盐废水中除硬和除硅的最佳条件,分别进行了双碱法混凝除硬实验和铝剂混凝除硅实验,结合单独除硬和除硅结果进行了加药混凝同时除硬除硅的实验,并研究了同步加药法和分步加药法对除硬除硅效果的影响。结果表明,双碱法混凝除硬的最优条件为NaOH、Na_(2)CO_(3)投加量分别为450、1 100 mg/L,Ca^(2+)、Mg^(2+)去除率分别为91.5%和83.5%;铝剂混凝除硅的最优条件为pH=8、NaAlO_(2)投加量为600 mg/L,全硅、Si_(a)和Si_(c)的去除率分别为90%、92%和80%;同步加药法中Ca^(2+)、Mg^(2+)去除率与单独除硬实验基本一致,而全硅、Si_(a)和Si_(c)去除率分别仅为39.8%、37.3%、40.3%;分步加药法先加入除硅药剂去除SiO_(2),再加入除硬药剂去除硬度,全硅、Si_(a)和Si_(c)去除率与单独除硅实验基本保持一致,而Ca^(2+)、Mg^(2+)去除率分别为91.5%和88.3%,Mg^(2+)去除率较单独除硬实验略有上升。分步加药法可高效同时去除高盐废水中的硬度和硅,在实际工业应用中具有较好前景。In order to explore the optimal removal conditions of hardness and silicon in high-salt wastewater,double alkali method coagulation for hardness removal experiment and aluminum agent coagulation for silicon removal experiment were carried out respectively.Combined with the results of individual hardness and silicon removal,experiments were conducted on the simultaneous hardness and silicon removal by adding coagulants,and the effects of synchronous and step-by-step dosing methods on the effect of hardness and silicon removal were studied.The results showed that the optimal conditions for hardness removal by double alkali coagulation were 450 mg/L NaOH and1 100 mg/L Na_2CO_3,respectively,and the removal rates of Ca^(2+)and Mg^(2+)were 91.5%and 83.5%,respectively.The optimal conditions for aluminum coagulation were pH=8,NaAlO_(2) dosage of 600 mg/L,and removal rates of allsilicon,Si_(a) and Si_(c) were 90%,92%and 80%,respectively.The removal rates of Ca^(2+)and Mg^(2+)in synchronous dosing method were basically consistent with the results of individual hardness removal experiment,while the removal rates of all-silicon,Si_(a) and Si_(c) were only 39.8%,37.3%and 40.3%,respectively.In the step-by-step dosing methods,the agent for silicon removal was first added to remove SiO_2,and then the agent for hardness removal was added to remove hardness.The removal rates of total silicon,Si_(a) and Si_(c) were basically consistent with that of individual silicon removal experiment,while the removal rates of Ca^(2+)and Mg^(2+)were 91.5%and 88.3%,respectively.The removal rate of Mg^(2+)was slightly higher than that of individual hardness removal experiment.The step-by-step dosing method could efficiently and synchronously remove hardness and silicon from high salt wastewater,which had a good prospect in practical industrial application.
分 类 号:X703[环境科学与工程—环境工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.30